Bedienungsanleitung Sanyo AWM660 (Seite 4 von 18) (Englisch)

29966

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

EXT.ANT

LOOP

ANT

PHONES

SPEAKERS

(4Ω MIN.)

EXT.ANT

LOOP

ANT

PHONES

SPEAKERS

(4Ω MIN.)

-E3-

SAFETY CERTIFICATION

This unit is made and tested to meet exacting safety standards. It

meets UL, CSA and FCC requirements and complies with safety

performance standards of the U.S. Department of Health and

Human Services.

CAUTION - USE OF CONTROLS OR ADJUSTMENTS OR PER-

FORMANCE OF PROCEDURES OTHER THAN THOSE SPECI-

FIED HEREIN MAY RESULT IN HAZARDOUS RADIATION

EXPOSURE.

THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANY-

ONE EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL.

CAUTION:

Changes or modifications not expressly approved by Sanyo may

void the user’s authority to operate this equipment.

NOTE:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or televi-

sion reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

NOTE:

To minimize noise...

• Keep the speaker wires, power cord and all other system con-

nection cables away from the loop antenna.

• Do not place the antenna close to the speaker.

CONNECTIONS

Antennas

FM antenna

The FM indoor antenna lead wire (see the back of the unit) is suffi-

cient to receive most local FM broadcasts.

Unwind the antenna lead wire, then extend it as straight as possible

and, while listening to the sound from the system, secure it in a

position where the best FM reception is found.

Screws (not supplied)

AM antenna

The AM loop antenna is sufficient to

receive most local AM broadcasts. As-

semble the loop antenna.

Unwind the antenna wires, then con-

nect them to the AM LOOP terminals.

Place the loop antenna in a position

which yields the best AM reception, or

attach it to a wall or other surface as

shown.

FCC INFORMATION

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

AWM-660/US Eng page 4/16/04, 5:40 PM4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sanyo AWM660 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info