70
Tr oubleshooting
Before calling your dealer or service center for assistance, check the items below once again.
– Make sure you have properly connected the projector to peripheral equipment as described on page 22~25.
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When you operate the projector with a computer and it does not project an image, restart the computer.
See Information by pressing the INFO. button to check the current projector condition before trying the solutions
below.
Problem: – Solutions
No power – Plug the power cord of the projector into the AC outlet.
– Make sure the Main On/Off switch is on.
– See if the LAMP indicator lights red.
– Wait 90 seconds after the projector is turned OFF when turning the
projector back on. The projector can be turned on after the READY indicator
turns green. (
☞ “Turning Off the Projector” on page 29)
– Check the WARNING TEMP. indicator. If the WARNING TEMP. indicator
lights red, the projector cannot be turned on.
(
☞ "Warning Temp Indicator" on page 62)
– Check the projection lamp. (
☞ page 64)
– Unlock Key lock for the projector in the Setting Menu. (
☞ page 56)
– Check if the air filter is fully installed and the filter cover is completely
closed. (
☞ page 63)
– Check the wattage of two lamps are the same. (☞ page 59, 64)
Image is out of focus. – Adjust focus of the projector. (
☞ page 30)
– Check the projection lens to see if it needs cleaning. (
☞ page 66)
– Moving the projector from a cool to a warm place may result in moisture
condensation on the projection lens. In such cases, leave the projector
OFF and wait until condensation disappears.
No image – Check the connection between your computer or video equipment
and the projector. (
☞ page 22–25)
– See if the input signal is correctly output from your computer. Some
laptop computers may need to change the setting for monitor output when
connecting to a projector. See your computer’s instruction manual for the
setting.
– It takes about 20 seconds to display an image after turning on the projector.
– See if the selected system is corresponding with your computer or video
equipment. (
☞ page 39–40)
– Select correct input source once again through menu operation.
(
☞ page 37–38)
– Make sure the temperature is not out of the specified Operating
Temperature (5°C ~ 35°C).
– Check if the shutter is released. (☞ page 30)
Image is dark. – Adjust Brightness and Contrast in the Image adjust menu. (
☞ page 45)
– Check the Shutter level. (
☞ page 55)
– Check each lamp condition and the LAMP 1/2 REPLACE indicators.
(☞ page 64, 69)
Image is Left/Right reversed. – Check the Ceiling / Rear item. (
☞ “Screen Setting” on page 49.)
Image is Top/Bottom reversed. – Check the Ceiling item. (
☞ “Screen Setting” on page 49.)
Appendix
