Bedienungsanleitung Sanyo SAP-CRV96EH (Seite 60 von 65) (Englisch)

639749

Zoom out

Zoom in

Vorherige Seite

1/65

Nächste Seite

7. HIGH POWER Mode

HIGH POWER mode can be used to increase the output of the

indoor unit for all operation modes except automatic operation.

Press the HIGH POWER button.

The mark appears in the display.

To cancel, press HIGH POWER button again.

• When the HIGH POWER button is pressed, the unit operates at

maximum output for 30 minutes, regardless of the desired

temperature. The fan speed is 1 step above “High”.

• HIGH POWER Mode cannot be used when the operation mode

is Automatic Operation.

• QUIET Mode and HIGH POWER Mode cannot be used at the

same time.

• When set to High fan speed during heating operation, the fan

runs at High fan speed even though the mark is displayed.

• Depending on the operating conditions, the fan speed may be

increased by a small amount only.

8. LED CLEAN Mode

In LED CLEAN mode, a UV anti-bacterial unit (including a LED

CLEAN lamp and anti-bacterial filter) in the indoor unit is used

during AUTO, HEAT, DRY, COOL, or FAN operation to remove

bacteria from air blown from the air conditioner.

Press the LED CLEAN button.

The mark appears in the display.

To cancel, press the LED CLEAN button again.

• When the LED CLEAN button is pressed, the UV anti-bacterial

unit operates for one hour and cleans air blown from the air

conditioner.

• Pressing the MODE selector button cancels LED CLEAN mode.

• Do not open the front panel while the LED CLEAN lamp on the

display is on.

• Depending on the room brightness, light from the LED CLEAN

lamp may reflect inside the air conditioner and be visible. This is

not a malfunction.

SPECIAL REMARKS

How it works?

• Once the room temperature reaches the level that was set, the

unit’s operation frequency is changed automatically.

• During DRY operation, the fan speed automatically runs at lower

speed for providing a comfortable breeze.

• ‘‘DRY’’ operation is not possible if the indoor temperature is 15 °C

or less.

Heating performance

• Because this air conditioner heats a room by drawing in the heat

of the outside air (heat pump system), the heating efficiency will

fall off when the outdoor temperature is very low. If sufficient heat

cannot be obtained with this air conditioner, use another heating

appliance together with it.

Defrosting

• When the outdoor temperature is low, frost or ice may form on

the heat exchanger coil, reducing heating performance. When

this happens, a microcomputer defrosting system operates. At

the same time, the fan on the indoor unit stops and the

OPERATION lamp lights red and orange alternately until

defrosting is completed. Heating operation restarts after several

minutes. (This interval will vary slightly depending upon the

outdoor temperature and the way in which frost forms.)

Cold draft prevention

• For several minutes after the start of heating operation, the

indoor fan runs at a lower speed until the indoor heat exchanger

coil has warmed up sufficiently. However, the fan may remain

stopped when the room temperature is low. This is because the

COLD DRAFT PREVENTION SYSTEM is in operation.

• In the event of power failure, the unit will stop. When the power is

resumed, the unit will restart automatically within five minutes by

the remote control unit.

Clicking sound is heard from the air conditioner

• In heating or cooling operation, any plastic parts may expand or

shrink due to a sudden temperature change. In this event, a

clicking sound may occur. This is normal, and the sound will

soon disappear.

• The remote control unit sends the setting condition to the air

conditioner regularly at five minute intervals.

NOTE

‘‘DRY’’ ( ) Operation

Heating ( ) Operation

Power failure during operation

Clicking Sound

Remote Control Unit

OI-002-11-EG

2column_01_SAP-KRV96EH_EN.fm Page 11 Wednesday, July 18, 2007 5:32 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sanyo SAP-CRV96EH Seite 60

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info