12-15”
3
4
5
Depress the rear wheel clamp lever, and rotate to open position.
Upright Arm
Press
Rotate
Open
Position
Push button on upright arm and rotate arm away from
center of rack.
Set bike into trays. Front wheel should be set into the front wheel
trays. Extend and rotate upright arm to vertical position. Push down
on upright arm to contact top of wheel's front tire. Once contact is
achieved, press down on upright arm for additional "clicks", until
wheel is held securely.
Rotate wheel so the largest gap is centered under wheel hub.
Align rear wheel clamp with largest gap in spokes of rear wheel.
Rotate clamp between spokes closing onto rear wheel tray.
Front Wheel Trays
Upright Arm
Upright Arm
(vertical position)
Push
***Note: For bicycles with odd rims or 40 spoke or greater
wheels, additional straps (available through Saris) should
be used in replace of the rear wheel clamp. Thread strap
into rear wheel tray slots and secure bicycle.
***Note: Bicycles with 20” wheels should be loaded
closest to vehicle.
Press
Rotate
Closed
Position
Removal of Bicycles: Reverse instructions 3-5 to
remove bicycle from rack.
Check clearance. It is the responsi-
bility of the user to ensure the nec-
essary clearance (dependent on
vehicle, load, driving territory, etc.) is
given from load to ground.
Generally, 12-15” is adequate. Load
smallest bicycle closest to the
vehicle. Lock bikes to rack with
locking cable provided. Lock must
pass through bikes and rack for total
security.
Slide arm
into base
Always stow arms in this position.
Push
Rotate
4B
4A
3
5A
5B
