Bedienungsanleitung Satel AOD-210 (Seite 4 von 13) (Englisch)

699623

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

2 AOD-210 SATEL

Radio communication

The detector connects to the controller / control panel at regular time intervals to provide

information about its state (periodical communication). Additional communication may take

place as a result of alarm (see “Operating modes”).

Alarms

The detector will report alarm:

 after detecting a motion in the protected area by both sensors within a time period shorter

than 4 seconds (this alarm can only be reported in the active mode – see “Operating

modes”),

 after detecting a fault in the motion detection system,

 when the light intensity drops below a defined threshold,

 after opening the tamper switch (tamper alarm).

Operating modes

Active – information about tamper alarm, motion detection alarm and light intensity drop

alarm is sent immediately. The microwave sensor is enabled after motion is detected by

the infrared sensor.

Passive – only information about tamper alarm and light intensity drop alarm is sent

immediately. The microwave sensor is disabled, therefore no alarm can be triggered after

motion is detected. During periodical communication, information on whether the PIR

sensor detects motion is sent. This operating mode prolongs the battery life.

The detector operating mode is turned on remotely. If the detector is used in the INTEGRA /

VERSA alarm system, the operating mode may depend on the partition state (partition

disarmed – passive mode; partition armed – active mode). For more information, refer to the

ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL control panel manual.

Energy saving mode (ECO)

If you want to prolong the battery life, you can enable in the detector the “ECO” option. When

the “ECO” option is enabled, the periodical communication takes place every 3 minutes. Thus

the battery life can be increased as much as fourfold. The option is only available in the

ABAX 2 system. The detector with “ECO” option enabled meets requirements of the

EN50131-2-4 standard for Grade 2.

Dusk sensor

Figure 1 shows the way the dusk sensor operates. On the timeline the T time delay is

presented (in operating mode T=15 min, in configuring mode T=3 s). Illustrated with the letter

H light intensity hysteresis and time delay make the sensor immune to short and accidental

changes of light intensity. Table 1 presents light intensity values for four detection thresholds.

For description of how to configure the sensor, please refer to the ABAX 2 / ABAX controller

manual / the INTEGRA 128-WRL control panel manual.

Information about the light intensity drop below the defined threshold (alarm) and the light

intensity restoration above the threshold (alarm restore) is sent instantly (regardless of the

operating mode).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel AOD-210 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel AOD-210

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info