Bedienungsanleitung Satel ASW-100 (Seite 2 von 3) (Englisch)

699888

Zoom out

Zoom in

Vorherige Seite

1/3

Nächste Seite

ASW-100 E / ASW-100 F ABAX

mode 1 - the button enables the electric circuit to be manually controlled – press the

button to close/open the 230V electric circuit (switch ON/OFF the device

connected to the controller socket).

mode 2 - the button enables the electric circuit to be manually controlled and the

remote control to be disabled – shortly press the button to close/open the

230V electric circuit (switch ON/OFF the device connected to the controller

socket). Press and hold down the button for 3 seconds to disable/enable the

remote control of the electric circuit (with remote control disabled, the LED

indicator is blinking).

The two-color LED provides the following information:

− steady green light – the 230V electric circuit is open (the device connected to the

controller socket is OFF)

− steady red light – the 230V electric circuit is closed (the device connected to the

controller socket is ON)

− blinking green light – remote control of the device is disabled, the 230V electric

circuit is open (the device connected to the controller socket is OFF)

− blinking red light – remote control of the device is disabled, the 230V electric circuit

is closed (the device connected to the controller socket is ON)

In addition, the LED will change its color momentarily during the polling: if

lighting/blinking green, it will give a red flash; if lighting/blinking red, it will give a green

flash.

2. Description of the installation

The ASW-100 E and ASW-100 F 230V wireless controllers should be installed

indoors, in spaces with normal air humidity.

Before plugging the wireless controller into the 230V socket, familiarize

yourself thoroughly with the electrical system in the premises. The phase

conductor in the socket the controller is to be plugged in should be on the

left-hand side, and the neutral conductor – on the right-hand side.

To install the ASW-100 E or ASW-100 F controller in the ABAX system, proceed as

follows:

1. Add the controller to the wireless system (refer to the ACU-100 controller user

manual). Placed on the housing is a sticker with the 7-digit serial number which is

to be entered when registering the controller in the system.

2. Plug the controller into the selected 230V socket.

3. Check the level of signal received by the controller from the controller. If

necessary, select another socket and re-check the signal level.

4. Having selected the installation place which ensures the optimum signal level,

configure the controller as required. Refer to the ACU-100 user manual for

configuration related information.

3. Technical data

Working frequency band............................................................. 868.0MHz ÷ 868.6MHz

Range.....................................................................................up to 150m (in open area)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel ASW-100 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel ASW-100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info