Bedienungsanleitung Satel integra 128-WRL (Seite 13 von 37) (Englisch)

699062

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

SATEL INTEGRA 128-WRL 11

When writing data to FLASH memory and when the STARTER program is running

(control panel firmware is being updated), the expander outputs are deactivated. The

status of the control panel mainboard outputs remains unchanged. Keep that in mind

when designing the system. It is recommended that devices whose operation must not

be disturbed as a result of writing data to FLASH memory or after launching the

STARTER program be connected to the mainboard outputs.

5.2 Estimation of the system current consumption

At the security system planning stage you should sum up the currents consumed by all

devices included in the system (control panel mainboard, keypads, additional modules,

detectors, sirens, etc.). The calculation should take into account the battery charging current.

If the sum of currents exceeds the maximum output current of the control panel power

supply, expander with power supply or an additional power supply unit should be used.

The sum of currents consumed by the devices connected to the power supply unit (expander

with power supply) must not exceed the power supply output current.

If you plan to connect devices to particular power outputs (of the control panel, expander with

power supply, etc.), remember that the sum of currents consumed by these devices must not

exceed the maximum current carrying capacity of those outputs.

5.3 Cabling

It is recommended that unscreened straight-through cable be used for making electric

connections between devices included in the system (using the twisted-pair type of cable,

e.g. UTP, STP, FTP, is not advisable).

If you use the twisted-pair type of cable, remember that the DTM and CKM / DT and

CK (data and clock) signals must not be sent through one twisted-pair cable.

It is recommended that separate cables be used for keypad bus and expander bus.

Select cross-section of the power supply wires so that the supply voltage drop between the

power supply and the supplied device should not exceed 1 V as against the output voltage.

In order to guarantee correct functioning of the system components it is important that

resistance and capacitance of the signal wires be as low as possible. When the distances

between the devices are greater, several wires connected in parallel may have to be used for

each signal, in order to reduce conductor resistance. This, however, may lead in

consequence to an increase in conductor capacitance. Too high resistance or capacitance of

the cables connecting the control panel to keypads or expansion modules can prevent the

devices from working correctly (e.g. the control panel will be unable to identify devices,

absence of devices will be reported, etc.). When selecting the length of cables, follow

recommendations set out in sections on connection of particular types of devices.

When making the cabling, remember that there must be sufficient distance between the low-

voltage wires and the 230 V AC power supply wires. Avoid running the signal cables in

parallel to and in close proximity of the 230 V AC supply cables.

5.4 Installation of control panel mainboard

The control panel mainboard contains electronic components sensitive to

electric charges.

You must complete all wiring, connections and device installations before

connecting the battery or applying AC mains to the control panel.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel integra 128-WRL Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel integra 128-WRL

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info