Bedienungsanleitung Satel Integra 64 (Seite 12 von 36) (Englisch)

699075

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

10 Installer Manual SATEL

5. System installation

Disconnect power before making any electrical connections.

The following tools will be useful during installation:

• blade screwdriver 2.5 mm,

• Phillips screwdriver,

• precision pliers,

• flat nose pliers,

• driller c/w a set of drill bits.

5.1 Installation plan

The installation must be preceded by preparation of a plan of the security alarm system. It is

advisable to draw up a sketch of the premises and mark on it all the devices that are to be

included in the alarm system: control panel, keypads, detectors, sirens, expansion modules

etc. The control panel and other alarm system components should be installed within the

protected area.

When writing data to FLASH memory and when the STARTER program is running

(control panel firmware is being updated), the expander outputs are deactivated. The

status of the control panel mainboard outputs remains unchanged. Keep that in mind

when designing the system. It is recommended that devices whose operation must not

be disturbed as a result of writing data to FLASH memory or after launching the

STARTER program be connected to the mainboard outputs.

5.2 Estimation of the system current consumption

At the security system planning stage you should sum up the currents consumed by all

devices included in the system (control panel mainboard, keypads, additional modules,

detectors, sirens, etc.). The calculation should take into account the battery charging current.

If the sum of currents exceeds the maximum output current of the control panel power

supply, expander with power supply or an additional power supply unit should be used.

The sum of currents consumed by the devices connected to the power supply unit (expander

with power supply) must not exceed the power supply output current.

If you plan to connect devices to particular power outputs (of the control panel, expander with

power supply, etc.), remember that the sum of currents consumed by these devices must not

exceed the maximum current carrying capacity of those outputs.

5.3 Cabling

It is recommended that unscreened straight-through cable be used for making electric

connections between devices included in the system (using the twisted-pair type of cable,

e.g. UTP, STP, FTP, is not advisable).

If you use the twisted-pair type of cable, remember that the DTM and CKM / DT and

CK / DT1 and CK1 / DT2 and CK2 (data and clock) signals must not be sent through

one twisted-pair cable.

It is recommended that separate cables be used for keypad bus and expander bus.

Select cross-section of the power supply wires so that the supply voltage drop between the

power supply and the supplied device should not exceed 1 V as against the output voltage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel Integra 64 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel Integra 64

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info