Bedienungsanleitung Satel Integra 64 (Seite 46 von 51) (Englisch)

699075

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

44 User Manual SATEL

4 short and 1 long beeps – the message has been confirmed, there are no more voice

messages,

2 long beeps – an invalid code has been entered (the message has not been confirmed).

If the control panel is sending messages about several events and confirmation of the

voice messages is required, each message should be confirmed. The first message

must be confirmed before the second message can be played back, an so on.

The installer can configure the control panel so that acknowledgement of receiving the

message by the user will:

− clear messaging other users,

− allow to get access to the INT-VG module voice menu.

10. Call answering and telephone control

The information below does not apply to the control panels to which the INT-VG

module is connected.

The call answering and telephone control functions are available to the users who have the

telephone code. These functions require that the DTMF dialing phone be used. The call

answering function allows to get information on the partition status (armed, disarmed). Owing

to the telephone control function, it is possible to control the REMOTE SWITCH type outputs

using the telephone.

10.1 Answering phone calls

1. Establish connection with the control panel, using one of the following methods (consult

the installer to learn which method is supported by the control panel):

single call – call the telephone number of control panel. The control panel will answer the

call after the number of rings programmed by the installer.

double call – call the telephone number of control panel. Hang up after the number of

rings programmed by the installer. Call again within three minutes. The call will be

answered by the control panel immediately.

Establishing connection will be signaled by three short beeps.

2. Enter the telephone code on the telephone keypad. 4 short beeps and 1 long beep will

confirm that you have got access to the call answering function. If the entered code is

invalid, this will be signaled by the control panel by two long beeps.

If you make a mistake when entering the code, enter the 4 digits anyway, and when

the control panel signals that the code is wrong, enter the correct code.

After entering three wrong codes, the control panel will hang up.

In case of a single call, if:

− no code has been entered and the connection is terminated,

− an invalid code has been entered and the connection is terminated,

the control panel will answer no calls for the next few minutes. It enables e.g. a fax to

be connected after the control panel.

3. Within up to 15 seconds, enter the 2-digit partition number (e.g. 01, 07 or 15). The control

panel will inform you about the partition status by means of sound signals:

3 short beeps – partition disarmed,

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel Integra 64 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel Integra 64

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info