Bedienungsanleitung Satel PERFECTA 32-WRL (Seite 28 von 49) (Englisch)

699526

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

26 PERFECTA SATEL

generated. Alarms from the 0. E

NTRY

XIT

, 1. E

NTRY

XIT FINAL

, 2. I

NTERNAL

, 3. I

NSTANT

4. D

OUBLE KNOCK

or 5. 24

URGLARY

zones are verified. The time is counted from the

moment of alarm triggering by this type of zone.

Exit delay clearing enable [Fin.exit delay] – if this option is enabled, the users can terminate

the exit delay countdown by using keypad (the , or key is to be pressed

and hold down for about 3 seconds).

Infinite exit delay [Infinit.ex.delay] – if this option is enabled, the exit delay time is infinite. It

can be terminated:

– on violation of the 1. E

NTRY

XIT FINAL

, 16. E

XIT

ELAY

ERMINATOR

or 17. S

HUNT

OCK

type zones,

– after pressing and holding down for 3 seconds the , or keys on the

keypad (when the E

XIT DELAY CLEARING ENABLE

option is enabled).

If the exit delay countdown is not terminated, the partition will not be armed.

Entry delay in Night Arm [Entry del. night] – if this option is enabled, there is entry delay

when the partition is armed in night mode. If this option is disabled, there is no entry delay

when the partition is armed in night mode.

Entry delay in Day Arm [Entry del. day] – if this option is enabled, there is entry delay when

the partition is armed in day mode. If this option is disabled, there is no entry delay when

the partition is armed in day mode.

6. Zones

A zone can be assigned to one or two partitions. If the zone is assigned to two partitions, it

can be armed when both partitions are armed or one of them only.

The system supports the following zones:

 hardwired – on the control panel PCB and in expanders. The number of available

hardwired zones is determined by the control panel during the identification procedure.

 wireless – in the PERFECTA 16-WRL or PERFECTA 32-WRL control panel, after adding

wireless detectors. The number of available wireless zones depends on the number of

wireless detectors registered in the system.

 virtual – zones which do not physically exist, but are controlled by means of keyfobs.

6.1 Zone parameters and options

Name [38.Names] – individual name of zone (up to 16 characters).

Wiring type [31.EOL] – type of detector and the method of its connection:

No detector – no detector is connected to the zone,

NC – the zone supports a detector of NC (normally closed) type,

NO – the zone supports a detector of NO (normally open) type,

EOL – the zone supports a detector of NO or NC type with EOL resistor in the circuit,

2EOL/NO – the zone supports a detector of NO type with two EOL resistors in the circuit,

2EOL/NC – the zone supports a detector of NC type with two EOL resistors in the circuit,

Roller – the zone supports a roller shutter detector,

Vibration – the zone supports a vibration detector (also NC type detector).

Opening the V

IBRATION

circuit for 200 ms or longer – irrespective of the programmed

number of pulses and sensitivity (see below) – will result in a zone violation. This

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel PERFECTA 32-WRL Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel PERFECTA 32-WRL

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info