Bedienungsanleitung Satel Versa Plus (Seite 10 von 11) (Englisch)

699394

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

8 VERSA Plus SATEL

The user can have two keyfobs:

 433 MHz keyfob – supported by the 433 MHz keyfobs receiver expansion module or 433

ecuted. The list of functions assigned to the

red the

MHz wireless system controlle

 APT-100 bidirectional keyfob – supported by the ABAX wireless system controller.

A single keyfob enables up to 6 functions to be ex

buttons / combination of buttons should be obtained from the person who configu

keyfob settings when adding / editing a user. In the case of APT-100 keyfob, that person

should also provide information about functionality of the LEDs. The keyfob LEDs can be

used to confirm execution of functions, as well as to indicate the system status (pressing

a button on the APT-100 keyfob is accompanied by the LEDs flashing rapidly three times,

and in a little while the LED(s) may come on for 3 seconds to provide information).

3. Operating the alarm system by telephone

You can operate the alarm system by using a touch-tone (DTMF

makes the operation an easy job. To access the voice menu, c

) telephone. The voice menu

all the phone number of the

control panel. Establish, in consultation with the installer, the phone number to call to get

access to the voice menu.

3.1 Starting the operating by telephone

1. Call the control panel phone number. After the

beeps.

call is received, you will hear three short

The installer can configure the control panel in such a manner that the analog

telephone communicator will only go off hook after the recall. If this is the case, call the

number, but hang up after the number of rings which has been set by the installer. Call

again within three minutes. The call will be received.

2. En

foll s to the interactive voice menu. If

ter the code from the telephone keypad and confirm by pressing #. 4 short beeps

owed by 1 long beep will confirm you have got acces

your code does not authorize you to get access, you will hear three long beeps in the

headset. If the code is incorrect, you will hear two long beeps in the headset.

The installer can allow for getting access to the voice menu from some defined phone

numbers without the code authorization (step 2 is skipped).

3. Me

telephone keys you should use to be able to operate the control panel.

ssages of the interactive voice menu will be played back. They will inform you which

3.2 Ending the operating by telephone

1. Press

key.

2. Press in turn the 0# keys. The control panel will go on-hook.

l panel will goes on hook automatically after one minute of idle state. The contro

S control 4. SM

The alarm system can

control commands. The

be operated by means of the SMS messages containing suitable

SMS message must be sent to the number of the currently used SIM

card. The contents of control commands is to be programmed by the installer. Additionally,

the installer defines what the control panel is to do after receiving the control command, as

well as which users and from which phone numbers can operate the control panel using the

SMS messages.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel Versa Plus Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel Versa Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info