757569
35
Zoom out
Zoom in
Vorherige Seite
1/136
Nächste Seite
SDH17-NW-U_EN - 05/14 - Saunier Duval
- 11 -
OPERATING INSTRUCTIONS
EN
7.3 Advice on how to use the remote
controller
Follow the recommendations below as to how to use the remote
controller:
When in use, direct the head of the signal transmitter directly
to the indoor unit receiver.
Keep the distance between the transmitter and the receiver
within 7 m.
Avoid obstacles between the transmitter and the receiver.
If experiencing difculties with the remote control
communicating with the indoor unit, reduce the distance
between the remote controller and the indoor unit.
Do not drop, throw or hit the remote controller.
7.3.1 Remote controller lock
In order to lock the buttons and display of the remote controller
device:
Press and hold the - & + buttons, at the same time for over
two seconds.
The rest of the buttons are deactivated.
The lock status indicator appears.
In order to deactivate the lock:
Press and hold the - & + buttons, at the same time again.
The rest of the buttons are activated.
The lock status indicator disappears.
7.3.2 Light function
Press the LIGHT button for less than 2 seconds to light the
display of the Indoor Unit. To switch the display back off, press
the LIGHT button for less than 2 seconds once again.
7.4 Switching the unit on and off
In order to switch the unit on:
Press the ON button on the remote controller; the unit will
start to operate.
In order to switch the unit off:
Press the OFF button on the remote controller; the unit will
stop.
7.5 Selection of the operation mode
7.5.1 Automatic mode (AUTO)
In automatic mode (AUTO) the Air to Air heat pump unit
automatically selects the cooling (COOL) or heating (HEAT)
mode in accordance with the actual ambient temperature.
In COOL mode the set room temperature is 25º C. Above
this room temperature the unit will operate in COOL mode.
In HEAT mode the set room temperature is 20º C. Below this
room temperature the unit will operate in HEAT mode.
Fig. 7.3 Automatic mode selection.
Legend
1 MODE button
2 - / + button
3 AUTO mode indicator
In order to activate:
With the unit switched on (see section 7.4):
Press the MODE button.
The different operation modes are displayed.
Fig. 7.4 Operation modes.
Select the automatic operation mode (AUTO).
Press the TEMP / TIME buttons to select the temperature
setting.
When pressing the - / + buttons, the temperature conguration
will increase or decrease by 1ºC.
1
2
3
35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Saunier Duval SDH 17 Mono wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info