Bedienungsanleitung Schaub Lorenz RW 260BT (Seite 18 von 24) (Deutsch, Englisch)

652761

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

18 | EN

a suitable wall socket.

3. Make sure that the output power of the wall outlet matches the required power of the adaptor.

Note:

• If not using the unit for a longer period of time, unplug the adaptor from the wall outlet and from

the unit.

Battery Backup Function

Two 1.5V “AAA” batteries (not included) can be installed as a backup option to maintain the time if

electrical power fails. In the event of a power outage, the time will not appear on the display, however,

the clock will continue to operate and the actual time will be maintained. The clock display will resume

once electrical power is restored if using the backup battery. The backup batteries should be replaced

as needed. Remove the batteries if the unit is not used or stored for long periods of time.

Basic Functions

Switching the Unit On & Off

1. Power the unit as described above.

2. The unit is now in standby mode.

3. To switch the unit on, press the STANDBY

/MODE button once. The unit will switch on to the

mode last selected.

4. To switch the unit off into standby mode, press and hold for 2 seconds the STANDBY

/MODE

button.

Mode Selection

• With the unit switched on, press the STANDBY

/MODE button repeatedly to switch between

the following modes: Radio, AUX, Bluetooth

Volume Control

• To increase the volume, press the Volume Up/Alarm 2 button.

• To decrease the volume, press the Volume Down/Alarm 1 button.

Clock Setting

The clock can only be set while the unit is in standby mode.

1. While the unit is in standby mode, press the Play/Pause button. The time will ash.

2. Press the PREV button to set the current hour.

3. Press the NEXT button to set the current minutes.

4. Once the time is set, press the Play/Pause button again to conrm and the display will go

back to displaying the set time in standby mode; the display will now show the set time.

Alarm Setting

An alarm can only be set while the unit is in standby mode.

This unit enables you to set 2 separate alarms. You can select to wake to Bluetooth

, Radio or Buzzer.

1. While the unit is in standby mode, press and hold for 2 seconds the Volume Down/Alarm

1 button (or the Volume Up/Alarm 2 button). (or ) will be shown in the display with

the time ashing).

2. In either alarm setting (alarm 1 or alarm 2) press the PREV button to set the desired alarm

hour and press the NEXT button to set the desired alarm minutes.

3. Once your desired time is set, press the Play/Pause button to conrm. Now press the

Volume Down/Alarm 1 button (or the Volume Up/Alarm 2 button) repeatedly to select

the desired wake up mode (Bluetooth

, Radio or Buzzer). The mode will be indicated in the

top left corner of the display.

4. Once the alarm mode is set, press the Play/Pause button to set the alarm volume. Press the

Volume Down/Alarm 1 button (or the Volume Up/Alarm 2 button) repeatedly to

increase/decrease the volume level.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Schaub Lorenz RW 260BT Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info