8 english
Manufacturer
Scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We wish you much pleasure and success with your new
scheppach machine.
Note
In accordance with valid product liability laws, the manu-
facturer of this device shall not be responsible for damage
to and from this device which results from:
-
nal scheppach replacement parts.
-
ance with the legal and applicable electrical directives
We recommend
that you read through the entire operating instructions be-
fore putting into operation.
These operating instructions are to assist you in getting to
know your machine and utilize its proper applications.
The operating instructions contain important notes on how
you work with the machine safely, expertly, and economi-
cally, and how you can avoid hazards, save repair costs,
reduce downtime and increase the reliability and service
life of the machine.
In addition to the safety requirements contained in these
operating instructions, you must be careful to observe your
country’s applicable regulations.
The operating instructions must always be near the ma-
chine. Put them in a plastic folder to protect them from
dirt and humidity. They must be read by every operator
before beginning work and observed conscientiously. Only
persons who have been trained in the use of the machine
and have been informed of the various dangers may work
with the machine. The required minimum age must be ob-
served.
In addition to the safety requirements contained in these
operating instructions and your country’s applicable reg-
ulations, you should observe the generally recognized
technical rules concerning the operation of woodworking
machines.
General notes
-
age. Inform the supplier immediately of any faults.
the machine by carefully reading these instructions.
-
placement parts. You can find replacement parts at your
scheppach dealer.
and year of construction of the machine.
dmt450
Included with delivery
Wood turner lathe
Tool holder
Driver (Fig. 1.2, A)
Live tailstock center
Tensioning spindle (Fig. 1.2, C)
Face plate
Open-end wrench SW 32 (figure 1.2, D)
Operating instructions
Technical data
Dimensions
L x B x H mm Bed height mm 190
Headstock thread Headstock taper MK 2
Height of centers
above bed mm Width between
centers mm 445
Diameter above
bed mm 254
Diameter between
centers mm 182
Length of tool
holder mm 150
Weight kg 34
Wood turning spindle with dust-proof precision grooved ball bearing
Revolutions 1/min Tailstock
Tailstock cone MK 2
Tailstock drill hole
(hollow spindle)
ø mm 9
Tailstock sleeve
adjustment mm Drive
Electric Motor Input P1 kW Output P2 kW 0,24
Revolutions 1/min 1360
Motor protection yes
Undervoltage
release yes
Switch - plug
combination Operating mode S6 40%
Noise parameters
The noise emission values at the work place, determined
31202 (acoustic pressure levels) with a correction factor
-
dix A, are:
Acoustic power level in dB
Idling LWAOperating LWAAcoustic pressure level in dB
Idling LpAeqOperating LpAeqA measuring uncertainty coefficient (K = 4 dB) applies to the
emission values listed above.
Subject to technical modifications!
