12 english
Maintenance
elimination of any malfunctions must only be undertak-
en after turning off the motor.
immediately upon completion of any repair or mainte-
nance work.
when changing tools.
by unscrewing it, cleaned and then sprayed with a dry
lubricant. Grease the threaded spindle.
tool holder and adjust if necessary. In addition, tighten
the hex nut under the bracket.
Accessories
ArticleArt. No.
Screw chuck7400 7200
Socket chuck Ø 30 mm7400 8600
Socket chuck Ø 40 mm7400 7300
Socket chuck Ø 60 mm7400 8700
Driver plate Ø 80 mm7400 8800
Three-jaw chuck Ø 100 mm7400 8900
Four-jaw chuck Ø 125 mm7400 7400
Drill chuck 3 – 16 mm cone mandrel MK-2 7400 7700
Trouble shooting
Problem Possible Cause Help
Motor doesn’t start b) Defective switch, condenser
c) Defective extension cord
a) Check fuse
b) Have an electrician inspect unit
necessary
Work piece flatters while
working
a) Working piece becomes loose
while working
b) Work piece is not properly centered
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Tool rest or tailstock
cannot be clamped
Setting the eccentric clamping
