18
This appliance meets the following CE standards:
DBT 73/23/CEE modified by 93/68/CEE
CEM 89/336/CEE
Before installing the appliance, the meter must be checked to verify the conditions for
the delivery of the available electrical power (number of phases, voltage, maximum
power) which must be compatible with the needs of the Scholtès appliance to be
installed.
There are two ways to connect the oven during installation:
- by using an electrical outlet
- or by using a connection panel.
In both cases, refer to the connection diagrams for the minimum diameters of the
wires and the calibration of the protective components according to the type of
connection.
If the installation is done using a connection panel, an omnipolar switchgear with a
minimum gap between contacts of 3 mm must be installed upstream from the
connection of the appliance.
We recommend that you use a power cord that is long enough to allow the removal of
the oven for maintenance operations. Use only cables of HAR - H 05 - RRF quality
equipped with a plug that complies with the regulations of the country where the
appliance is installed.
The plug must be accessible.
Before any maintenance or repair operation, including replacing the light bulb,
you must first disconnect the appliance.
It is hazardous to operate an appliance that has not been properly earthed.
Important: After connecting the appliance to the flexible cable, tighten all the screws
on the terminal plate
Electrical Connection
