Bedienungsanleitung Scholtes FN36XA (Seite 24 von 64) (Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

536324

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

 The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

 The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

 The accessories can be washed like everyday

crockery, and are even dishwasher safe.

 Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

For more thorough cleaning purposes, the oven door

may be removed:

1. Open the oven door fully (see diagram).

2. Lift up and turn the small levers located on the

two hinges (see diagram).

3. (with glass panel fitted to

the inside of the door) Grip the

door on the two outer sides

and close it approximately

half way. Unlock the door by

pressing on the clamps .,

then pull the door towards

you, lifting it out of its slot

(see diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven at regular

intervals. If the seals are damaged, please contact

your nearest Service Centre (see Assistance). We

recommend that the oven is not used until the seals

have been replaced.

Replacing the light bulb

To replace the

oven light bulb:

1. Remove the glass cover using a screwdriver.

2. Unscrew the light bulb and replace it with a

similar one: Wattage 15 W, cap E 14.

Replace the glass cover, making sure the seal is

positioned correctly (see diagram).

Assistance

Warning:

The appliance is fitted with an automatic diagnostic

system which detects any malfunctions.

Malfunctions are signalled through messages of the

following type: F, followed by numbers.

Call for technical assistance in the event of a

malfunction.

 Never use the services of an unauthorised

technician.

Please have the following information to hand:

 the type of problem encountered;

 the appliance model (Mod.);

 the serial number (S/N).

The latter two pieces of information can be found on

the data plate located on the appliance.

Glass door

Seal

Lamp

Oven

compartment

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scholtes FN36XA Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info