GB
17
Control panel - HL 997
ON (Stand by)/OFF: press the button for 3
seconds to obtain the ON (Stand by) condition; all the
buttons/commands are enabled.
ON/OFF lights
Adjusting suction power:
Press to increase or to decrease and switch off
the suction power. The button switches on to
indicate that the hood is functioning. It switches off
when the hood returns to Standby (motor off).
NOTE: If the hood is not being used, we advise turning
it off by pressing the button twice (the LED that
illuminates the key will switch off).
Intensive suction power (timed)
Press this button to reach maximum suction power for
a period of 5 minutes (the button flashes to
indicate that intensive suction power is functioning). At
the end the hood returns to the speed set previously.
To exit in a d v a n c e fro m th e fu n c t i o n , pre s s the s a m e
key again.
Carbon filter saturation signal
This button lights up when maintenance of the carbon
filter is necessary.
To re s e t th e si g n a l , press t h e same b u t t o n for a long
time (at least 3 seconds) until the confirmation beep is
heard.
This signal is normally off. Proceed as follows to
activate it:
With the hood in the off position, press the button.
First the lights up, after about a second the
button also lights up indicating that the carbon filter
saturation signal has been activated. Release the key.
If you want to deactivate the carbon filter saturation
signal previously set, repeat the operation:
First the two and buttons light up: then the latter
goes out, indicating the deactivation of the signal.
Grease filter saturation signal:
This key lights up when maintenance of the grease
filter is necessary. To reset the signal, press the same
button for at least 3 seconds until the confirmation
beep is heard.
Control panel - HL 998 - HLS 998
ON (Stand by)/OFF: press the button for 3
seconds to obtain the ON (Stand by) condition; all the
buttons/commands are enabled.
ON/OFF lights
Press or once with the light off to switch on the
light.
Press or with the light on to adjust the intensity
of the light.
Press or once with the light on to switch the
light off.
Adjusting suction power
Press to increase or to decrease and switch off the
suction power. The button switches on to indicate
that the hood is functioning. It switches off when the
hood returns to Standby (motor off).
NOTE: If the hood is not being used, we advise turning
it off by pressing the button twice (the LED that
illuminates the button will switch off).
Intensive suction power (timed)
Press this button to reach maximum suction power for
a period of 5 minutes (the button flashes to
indicate that intensive suction power is functioning). At
the end the hood returns to the speed set previously.
To exit in a d v a n c e fro m th e fu n c t i o n , pre s s the s a m e
button again.
Carbon filter saturation signal
This button lights up when maintenance of the carbon
filter is necessary.
To re s e t th e si g n a l , press t h e same b u t t o n for a t least 3
seconds until the confirmation beep is heard.
This signal is normally off. Proceed as follows to
activate it:
With the hood in the off position, press the button.
First the button lights up, after about a second the
button also lights up indicating that the carbon filter
saturation signal has been activated. Release the button.
If you want to deactivate the carbon filter saturation
signal previously set, repeat the operation:
First the two and buttons light up: then the
latter goes out, indicating the deactivation of the
signal.
Grease filter saturation signal
This button lights up when maintenance of the grease
filter is necessary. To reset the signal, press the same
