495414
17
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
17
EN
A
B
D
C
Start-up and use
* Only available in selected models.
Starting the dishwasher
1. Turn the water tap on.
2. Open the door and press the ON/OFF button: the
indicator light will illuminate.
3. Measure out the detergent (see below).
4. Load the racks (see Loading the racks).
5. Select the programme by pressing the WASH CYCLE
SELECT button; the corresponding indicator light will
illuminate.
6. Select the wash options (see below).
7. Start the wash cycle by shutting the door: the machine
will emit a confirmation beep.
8. At the end of the cycle two short beeps will sound and
the WASH CYCLE indicator light will flash. Open the door,
switch off the appliance by pressing the ON/OFF button,
shut off the water tap and unplug the appliance from the
electricity socket.
9. Wait for a few minutes before removing the crockery, in
order to avoid burns. Unload the racks, beginning with the
lower level.
Modifying a wash cycle in progress
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that it
has only just begun: open the door, taking care to avoid the
escaping steam, and press the WASH CYCLE SELECT
button, holding it for 4 seconds. After one long beep and
three short beeps, the WASH CYCLE indicator light will
switch off: select the new wash cycle and start the
programme by shutting the door.
Adding extra crockery
Open the door, taking care to avoid the escaping steam,
and place the crockery inside the dishwasher. Close the
door: the cycle starts from the point at which it was
interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the
electricity supply is restored.
Loading the detergent
A successful wash also depends on the correct amount of
detergent being used, as recommended by the
manufacturer. Exceeding the recommended amount does
not result in a more effective wash and pollutes the
environment.
To obtain the best results from each washing and drying
cycle, powder detergent, rinse aid liquid and salt should be
used.
compartment Acompartment A
compartment Acompartment A
compartment A: Washing detergent
compartment Bcompartment B
compartment Bcompartment B
compartment B: Pre-wash detergent
1. Open cover C by pressing button D.
2. Pour in the detergent
after consulting the
Wash
cycle table
:
• for powder detergent use
compartments A and B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle requires
1 tablet, place it in
compartment A and close
the cover; when it requires
2, place the second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
Washing options
Delayed start
It is possible to delay the start time of the cycle by 2, 4 or 6
hours.
1. Press the DELAYED START button: every time the button
is pressed, a beep is emitted and the selected delayed
start indicator light illuminates.
2. Select the wash cycle and shut the door: after the beep
sounds, the timer begins counting down.
3. Once this time has elapsed, the indicator light switches
off and the wash cycle begins.
To adjust the delay time and select a smaller period of time,
press the DELAYED START button. To cancel it, press the
button repeatedly until the selected delayed start indicator
light switches off. The wash cycle will start automatically as
soon as the door is shut.
Half load using the upper or lower rack*
If there are not many dishes to be washed, a half load cycle
may be used in order to save water, electricity and
detergent. Before selecting the wash cycle press the HALF
LOAD button repeatedly: the indicator light will illuminate
and the wash cycle will take place only in the upper or the
lower rack.
Remember to load the upper or lower rack only, and to
reduce the amount of detergent accordingly.
It is better to use powder detergent in this case.
Extra drying*
To make sure that the crockery is completely dry at the end
of the cycle, press the EXTRA DRYING button before
selecting the wash cycle. A prolonged beep will sound to
indicate that this option has been selected and a short beep
will sound to indicate when it has been deselected.
This option is incompatible with the soak cycle.
If the Extra drying option is selected, the wash cycles will
last longer.
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Scholtes LVTI 12-56 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info