Bedienungsanleitung Scholtes lvx 12 56 wh (Seite 23 von 60) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

126890

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Cleaning and Special Maintenance

Cleaning the Sprayer Arms

It may happen that food particle become encrusted on the

sprayer arms and block the holes (see "Close up view

(interior)", letters F-I). Check the sprayer arms periodically and

clean them when needed.

Troubleshooting

It may occur that the dishwasher does not function or does not

function properly. Before calling for assistance, let us see what can

be done first: have you forgot to press one of the buttons or to

perform an essential operation?

The Dishwasher Does Not Start

Have you checked whether:

- the plug is pushed into the socket correctly;

- the power is on in the house;

- the door is closed properly;

- the ON-OFF switch is on "ON";

- the water supply is turned on.

The Dishwasher Does Not Load Water

Have you checked whether:

- the water is turned on and the hose is connected properly;

- the water supply to the house is on and has sufficient

pressure;

- the water supply hose is crimped or bent;

- the filter for the water supply hose is clogged.

The Dishes Are Not Clean

Have you put the right amount of detergent into the dispenser?

Is the wash cycle suitable for the dishes you have placed inside the

appliance?

Are the filter and microfilter clean?

Can the sprayer arms turn freely?

The Dishwasher Does Not Drain

Have you checked whether:

- the drain hose is crimped or bent.

Lime Deposits or a White Film Form on the Dishes

Have you checked whether:

- the lid to the salt container is closed properly;

- the rinse aid dosage is correct.

Error messages.

Your dishwasher is equipped with a safety system which is able to

detect any operating anomalies.

These anomalies or faults are signalled by several codes consisting

of letters and numbers that flash up on the display. Make a note of

the error code that appears, turn the appliance off, turn off the

water tap and call for technical assistance.

Tap off alarm

If you have forgotten to turn on the water tap, your appliance

will remind you with a long series of prolonged beeps and the

wording H2O will flash up on the display. Turn the tap on and

the wash cycle will start up after a few minutes.

If you are not there when this signal appears, the appliance

will switch to alarm mode and the code “A06” will flash on the

display.

Turn the appliance off at the ON-OFF button, turn on the water

tap and wait approximately 20 seconds before turning the

appliance back on.

Re-select a wash cycle as indicated in the "Starting and setting

the cycle"paragraph and the appliance will start.

Clogged filter alarm

If the appliance is blocked and the code “A05” is flashing, this

means the filter is clogged by large particles of food residue.

Turn the display off by keeping the Stand-by button pressed.

Clean the filter thoroughly and reposition it in its seat as

illustrated on this page. Then turn it back on. Repeat the

programming operations and the appliance will start.

Water load solenoid valve malfunction alarm

If the code "A02" flashes,TURN the dishwasher OFF AND BACK

ON AGAIN after one minute. If the alarm persists, first turn off

the water tap to avoid any flooding and then cut off the electricity

supply and call for technical assistance.

If, despite all these checks, the dishwasher still does not function

and/or the problem persists, contact the nearest authorised

service centre and provide them with the following information:

- the nature of the problem;

- the model type number (Mod. ...) and the serial number (S/N

....), which are indicated on the plate located on the side of

the inner part of the door.

Never call on unauthorised technicians and refuse to

allow parts to be installed that are not original spare

parts.

The filter assembly

If you want consistent good results from your dishwasher,

you need to clean the filter assembly.

The food particles are removed from the wash water,

allowing it to be recirculated during the cycle, filtered

perfectly. For this reason, it is a good idea to remove the

larger food particles trapped inside the cup “C” and the

semi-circular filter A after each wash; pull the cup handle

upwards to remove them. Just rinse them under running

water.

The entire filter assembly should be cleaned thoroughly

once a month: cup C + semi-circular filter A + cylindrical

filter B. Rotate filter “B” anticlockwise to remove it.

For cleaning, use a non metallic brush.

Reassemble the filter parts (as shown in the figure) and

reinsert the whole assembly into the dishwasher. Position it

into its housing and press downwards.

The dishwasher is not to be used without filters. Improper

replacement of the filters may reduce the efficiency of the

wash and even damage your dishwasher.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scholtes lvx 12 56 wh Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info