Bedienungsanleitung Scholtes pp 93 g (Seite 12 von 44) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch)

331799

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

· total free cross section of passage of at least 6 cm² for

every kW of rated heating capacity of the appliance, with

a minimum of 100 cm² (the heating capacity is indicated

on the rating plate);

· it must be made in such a way that the aperture, both on

the inside and outside of the wall, cannot be obstructed;

· it must be protected, e.g. with grills, wire mesh, etc. in

such a way that the above-mentioned free section is not

reduced;

· it must be situated as near to floor level as possible.

Detail A Adjacent Room to be

room ventilated

Examples of ventilation holes Enlarging the ventilation slot

for comburant air between window and floor

Fig. 2A Fig. 2B

The air inflow may also be obtained from an adjoining room,

provided the latter is not a bedroom or a room where there

is a risk of fire, such as garages, mews, fuel stores, etc.

and is ventilated in compliance with the standards in force.

Air from the adjoining room to the one to be ventilated may

be made to freely pass through permanent apertures with

a cross section at least equal to that indicated above. These

apertures may also be obtained by increasing the gap

between the door and the floor (fig.2B).

If an electric fan is used for extracting the combustion

products, the ventilation aperture must be increased in

relation to its maximum performance. The electric fan

should have a sufficient capacity to guarantee an hourly

exchange of air equal to 3-5 times the volume of the kitchen.

Prolonged, intensive use of the appliance may require extra

ventilation, e.g. an open window or a more efficient

ventilation system by increasing the extraction power of

the electric fan if installed.

Liquid petroleum gas descends towards the floor as it is

heavier than air. Apertures in the outside walls in rooms

containing LPG cylinders should therefore be at floor level,

in order to allow any gas from leaks to be expelled. Do not

store LPG cylinders (even when empty) in basements/

rooms below ground level; it is advisable to keep only the

cylinder in use in the room at any one time and connected

far from heat sources which could raise its temperature to

above 50 °C.

The following instructions are provided for qualified installers

so that they may accomplish installation, adjustment and

technical maintenance operations correctly and in

compliance with current regulations and standards.

Important: the hob should be disconnected from the

mains electricity supply before any adjustment,

maintenance, etc. is carried out. Maximum caution should

be used whenever it is necessary to keep the appliance

connected to the electricity supply.

The hobs have the following technical characteristics:

-Category II 2H3+ Class 3

Positioning

This appliance may only be installed and operated in

permanently ventilated rooms in compliance with provisions

laid down by current regulations and standards. The

following requirements must be observed:

• The appliance must discharge combustion products into

a special hood, which must be connected to a chimney,

flue pipe or directly to the outside (fig.2).

• If it is impossible to fit a hood, the use of an electric fan

is permitted, either installed on a window or on an external

wall, which must be switched on at the same time as the

appliance.

In a chimney stack or branched flue Directly to the outside

(exclusively for cooking appliances)

Kitchen ventilation

The air flow into the room where the appliance is installed

must equal the quantity of air that is required for regular

combustion of the gas and for ventilating the same room.

Air must be taken in naturally through permanent apertures

made in the outside walls of the room or through single or

branching collective ventilation ducts in compliance with

the standards in force.

The air must be taken directly from the outside, from an

area far from sources of pollution.

The ventilation aperture must have the following

characteristics (fig.2A):

INSTRUCTIONS FOR THE INSTALLER

fig.1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scholtes pp 93 g Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info