Bedienungsanleitung Schwinn 125 Upright Bike (Seite 22 von 36) (Englisch)

671403

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

LCD Display Data

RPM

KCAL

LEVEL

RESULTS

TIME

SPEED

DISTANCE

Program Display

The Program Display shows the name of the program selection and the grid area shows the course profile for the program.

Each column in the profile shows one interval (workout segment). The higher the column, the higher the resistance level for

that interval. The flashing column shows your current interval.

Time

The TIME display field shows the time count in the workout. If no preset time is set up for the current workout program, the

displayvaluestartsatzeroandcountsforwarduntiltheendoftheworkout.Maximumtimeis99:59.

If the workout has a preset time, the display starts at the preset value and counts down to zero. The display shows the total

time count for the workout.

Speed / Distance

The SPEED/DISTANCE display field shows the machine speed in kilometers per hour (km/h) or miles per hour (mph) for 6

seconds, then the Distance for 6 seconds. The Distance display shows the distance count (miles or km) in the workout.

Note:TochangethemeasurementunitstoEnglishImperialormetric,refertothe“ConsoleSetupMode”sectioninthis

manual.

RPM / KCAL (Calories)

TheRPM/KCALdisplayfieldshowsthemachinerevolutionsperminute(RPM)for6seconds,thentheKCALdisplayshows

theestimatedcaloriesthatyouhaveburnedduringtheexercisefor6seconds.

Level / HR (Heart Rate)

TheLEVEL/HRdisplayfieldshowsthecurrentresistancelevel(1–16)for6seconds,thenyourHeartRatefor6seconds.

The HR display shows the heart rate in beats per minute (BPM) from the Contact Heart Rate sensors.

Consultaphysicianbeforeyoustartanexerciseprogram.Stopexercisingifyoufeelpainortightnessinyourchest,

become short of breath, or feel faint. Contact your doctor before you use the machine again. Use the values calculated

or measured by the machine’s computer for reference purposes only.

Contact Heart Rate Sensors

Contact Heart Rate (CHR) sensors send your heart rate signals to the Console. The CHR sensors are the stainless steel parts

of the Handlebars. To use, put your hands comfortably around the sensors. Be sure that your hands touch both the top and

the bottom of the sensors. Hold firm, but not too tight or loose. Both hands must make contact with the sensors for the Con-

sole to detect a pulse. After the Console detects four stable pulse signals, your initial pulse rate will be shown.

Once the Console has your initial heart rate, do not move or shift your hands for 10 to 15 seconds. The Console will now

validate the heart rate. Many factors influence the ability of the sensors to detect your heart rate signal:

• Movement of the upper body muscles (including arms) produces an electrical signal (muscle artifact) that can interfere with

pulse detection. Slight hand movement while in contact with the sensors can also produce interference.

• Calluses and hand lotion may act as an insulating layer to reduce the signal strength.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Schwinn 125 Upright Bike Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info