Bedienungsanleitung Scott MTB E-bike 2018 (Seite 15 von 33) (Englisch)

779976

Zoom out

Zoom in

Vorherige Seite

1/33

Nächste Seite

ENGLISHENGLISH 29 |

KIDS’ TOY BICYCLE | OWNER’S MANUAL 2017OWNER’S MANUAL 2017 | KIDS’ TOY BICYCLE

| 28

b ca e fd

Checking the back-pedal brakes

Turn the cranks with the pedals backwards. The brake must respond after 60

degrees at the latest. If it does not, the brake may be defective or the chain too

slack.

Readjustment of the chain tension

With back-pedal brakes the chain tension has to be checked regularly. You

should not be able to pull the chain upwards by more than two centimetres in

the middle between sprocket and chainring. Make sure there is no excessive

chain slack! For more details read the chapter “Bicycle chain”.

Before adjusting the chain tension appropriately, release the brake torque arm

(a) and the wheel nuts (b). Tension the chain before tightening the wheel nuts

by pulling the wheel to the rear. Make sure there is not more than two centime-

tres of play midway between sprockets and chainring.

Check the centred position of the wheel between the drop-outs. Tighten the

wheel nuts and the bolts of the torque support to the specified torque values

(see the chapter “Recommended torque settings for your SCOTT toy bicycle“).

DANGER!

Check regularly whether the torque support (brake torque arm) (a) is firmly

attached to the frame or fork. Use a torque wrench (c) and never exceed

the maximum torque value!

DANGER!

Keep in mind that the back-pedal brake is ineffective with a fallen-off chain.

Risk of an accident!

BICYCLE CHAIN

Regular and correct lubrication of your bicycle chain ensures enjoyable riding

and prolongs its service life. It is not the quantity but the distribution and regular

application of lubricant that counts. Clean the dirt and oil off your chain with an

oily rag from time to time. Special degreasers are not necessary; they even have

a damaging effect.

Having cleaned the chain as thoroughly as possible, apply chain oil, wax or

grease to the chain links (d). To lubricate the chain, drip the lubricant onto the

rollers of the lower run of the chain while you turn the crank. Once this is done,

turn the cranks a few more times; then let the bicycle rest for a few minutes so

that the lubricant can disperse.

Finally wipe off excess lubricant with a rag so that it does not spatter around

during riding or can collect road dirt.

Although the chain is one of the wearable parts of the bicycle, there are still

ways for you to prolong its life. Make sure the chain is lubricated regularly, espe-

cially after riding in the rain.

Your SCOTT dealer has accurate measuring instruments for checking the chain

wear (e). The replacement of the chain is a job for a skilled mechanic, as you

need specific tools.

DANGER!

Check the chain tension (f) according to the SCOTT service and mainte-

nance schedule. For more information see the chapter “Readjustment of

the chain tension”.

DANGER!

Make sure the braking surfaces of the rims and the brake pads remain clear

of lubricants, as the brakes will fail otherwise!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scott MTB E-bike 2018 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Scott MTB E-bike 2018

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info