664164

Scott Toy Bike - 2016 Seite 19

19
Zoom out
Zoom in
Vorherige Seite
1/33
Nächste Seite
ENGLISHENGLISH
37 |
KIDS’ TOY BICYCLE | OWNER’S MANUAL 2017OWNER’S MANUAL 2017 | KIDS’ TOY BICYCLE
| 36
b ca e fd
Tyre removal
Remove the cap and the fastening nut off the valve and deflate the tyre com-
pletely (a). Press one tyre side from the rim sides towards the centre of the rim
(b). This will ease the removal.
Apply a plastic tyre lever to one bead of the tyre about 5 cm beside the valve
and lever the tyre out of the rim in this area (c). Hold the tyre lever tight in its
position. Slip the second tyre lever between rim and tyre at a distance of about
ten centimetres on the other side of the valve and lever the next portion of the
bead over the edge of the rim.
After levering a part of the tyre bead over the edge of the rim you should
normally be able to slip off the whole tyre on one side by moving the tyre lever
around the whole circumference. Now you can remove the inner tube. Make
sure the valve does not get caught in the rim, as this can damage the inner tube.
If necessary, you can remove the whole tyre by pulling the other tyre bead off
the rim. Repair the puncture according to the instructions of the repair kit manu-
facturer or replace the inner tube by a new one.
When you have removed the tyre, you should also check the rim tape (d). It
should lie squarely in the rim trough, covering all spoke nipples, and should nei-
ther be damaged nor brittle.
DANGER!
G
If the fabric of the tyre is destroyed by the perforating object, replace the
tyre to be on the safe side.
NOTE!
I
If you get a puncture en route, inflate the inner tube and bring it close to
your ear. In most cases you can hear the air coming out. At home you can
help yourself with a bucket of water where you can locate the hole by the bub-
bles. When you have found the hole, look for the corresponding place on the
tyre and check it, as well. Often, you will find a foreign body sticking in the tyre,
which ought to be removed. Otherwise another puncture can occur.
Tyre mounting
When mounting a tyre make sure no foreign matter, such as dirt or sand, gets
inside the tyre and you do not damage the inner tube in the process.
Slip one bead of the tyre onto the rim. Using your thumbs, press one bead over
the edge of the rim and then around the entire circumference (b). This should
normally be possible without using tools.
Stick the valve of the inner tube through the hole in the rim (e). Inflate the inner
tube slightly so that it becomes round and push it into the tyre all the way round
(f). Make sure not to leave any folds in the inner tube.
To finish mounting the tyre, start at the opposite side of the valve. Using your
thumbs, press as much of the second bead of the tyre over the edge of the rim
as you can.
Make sure the inner tube does not get pinched and squashed between the tyre
and the rim. You can prevent this by pushing the inner tube into the hollow of
the tyre with a finger as you work along.
Work the tyre into the rim by approaching the valve symmetrically from both
sides. Towards the end, you will have to pull the tyre vigorously downwards to
make the already mounted portion of the tyre slip towards the deepest part of
the rim well. This will ease the job noticeably on the last centimetres.
Before fitting the tyre completely on the rim check again whether the inner tube
lies properly inside the tyre and press the last stretch of tyre over the edge of
the rim using the balls of your thumbs (b).
If this does not work, you will have to use the tyre levers (c). Make sure the bent
ends point towards the inner tube and the inner tube does not get damaged.
Push the valve a little into the tyre so that the inner tube does not get caught
between the rim and the tyre beads. Check whether the valve stands upright. If
not, dismount one bead again and reposition the inner tube.
… 19 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Scott Toy Bike - 2016 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Scott Toy Bike - 2016

Scott Toy Bike - 2016 Bedienungsanleitung - Deutsch - 33 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info