Bedienungsanleitung Scott Trekking - 2016 (Seite 33 von 80) (Englisch)

664166

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ENGLISHENGLISH

65 |

TREKKING AND TREKKING-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2017ORIGINAL OPERATING INSTRUCTIONS 2017 | TREKKING AND TREKKING-PEDELEC

| 64

DANGER!

Loose connections or leaky brake lines can drastically impair braking

power. If you find leaks in the brake system or buckled lines, contact your

SCOTT dealer. Risk of accident!

Functional check

Check whether the brake pads are accurately aligned with the rims (c) and still

sufficiently thick. You can judge the wear of the brake pads by the appearance

of grooves. If the pads are worn down to the bottom of the grooves, it is time to

replace them. Be sure to observe the appropriate instructions of the respective

manufacturer.

See your SCOTT dealer and ask him to examine the remaining thickness of the

rims when you are through your second set of brake pads at the latest. Your

SCOTT dealer has special measuring devices for determining the remaining

thickness of the rims (d).

The brake pads must hit the rim simultaneously and in parallel (e). This setting is

to prevent the brake pads from screeching when applied.

The brake lever must always remain clear of the handlebars. You should not be

able to pull it all the way to the handlebars (f), not even in the event of an emer-

gency stop. If this is the case, however, observe the following chapter “Synchro-

nising and readjusting”.

A correctly adjusted brake is only ensured if all of these checks have been made

successfully.

DANGER!

Adjusting the position of the brake pads relative to the rims requires a

considerable degree of skill. Replacing and adjusting the brake pads is a job

best left to your SCOTT dealer.

DANGER!

Have your rims regularly inspected and measured by your SCOTT dealer.

To readjust the brakes, unscrew the knurled lock ring located at the point where

the brake cable enters the brake lever on the handlebars (a). Unscrew the

knurled, slotted adjusting bolt by a few turns. This reduces the free travel of the

brake lever. Keeping the adjusting bolt firm, tighten the lock ring against the

brake lever unit. This prevents the adjusting bolt from coming loose by itself.

Ensure that the slot of the bolt faces neither forward nor upward, as this would

permit water or dirt to enter more easily.

DANGER!

Always test the brakes’ function when stationary after adjusting them and

make sure the brake pads engage fully with the rim without touching the

tyre, when you pull them hard.

Hydraulic rim brakes

Operation and wear

Common hydraulic rim brakes consist of two brake assemblies that are mount-

ed on the left and right side of the rim and are connected by an assembly plate

and, if necessary, by a brake booster (b).

Actuating the brake lever compresses the hydraulic pistons through oil pressure,

pushing the brake pads against the rims.

The friction generated by braking causes wear to the brake pads as well as to

the rims. Frequent rides in the rain and dirt and on uneven ground can ac-

celerate wear on both braking surfaces. Some rims are provided with wear

indicators, e.g. grooves or circular indentations. If the rim is worn down to the

point where the grooves or indentations are no longer visible, they need to be

replaced.

Once the abrasion of the rim has reached a certain critical point, the rim may

break under the tyre pressure. This can make the wheel jam or the inner tube

burst, both of which can cause an accident. Risk of falling!

Keep the hydraulic brake assemblies, especially the brake pad area, clean, as

dirt can prevent the pads from travelling back in their rest position. Regularly

check the lines and connections for leaks.

b ca e fd

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scott Trekking - 2016 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Scott Trekking - 2016

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info