Bedienungsanleitung SEAFARER 5 (Seite 10 von 13) (Englisch)

634236

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

display will flash. This "missing echo" indication will

continue until a satisfactory echo has been obtained

from the sounder. The minimum reading on the

repeat meter is 0.8 metres (or 2.7 feet) and has

been

set by a bubble suppression circuit. This is to prevent

false readings which could be caused by aeration at

the interface between boat and water.

GUARANTEE AND SERVICE

The Seafarer 5 and 700 are fully guaranteed under

the conditions as stated on the guarantee card

supplied with the instrument. After the guarantee

expires, or if problems arise which are not covered by

the terms of the guarantee, your instrument will be

repaired in the United Kingdom by the

manufacturers or by one of their officially authorised

main distributors.

Unauthorised or inexperienced

persons should not attempt to service the instrument

since this is not only likely to worsen whatever fault

has arisen, but will immediately nullify the

Guarantee. Should it ever be necessary to return the

nstrument for service it is essential that the internal

battery be removed and that the instrument be

carefully packed and insured for transit. A brief note

giving your name and address) and the symptoms of

allure is of great assistance to service engineers in

ocating a fault.

Routine Maintenance

The transducer should be examined periodically and

if fitted outside the hull a thin coat of hard anti-

fouling paint should be applied to the face of the

transducer with a soft brush, care being taken not to

trap air bubbles under the paint. A build-up of

barnacles and other marine encrustation on the face

of the transducer will cause progressive deterioration

of the instrument maximum depth capability.

Barnacles should be removed by crushing between a

pair of pliers and not tugged off as the transducer

£ace may become irreparably damaged. Particles of

mbedded shell can be dissolved by applying a 20%

solution of dilute hydrochloric acid, and be rinsed off

with fresh water. If an internal battery is fitted, this

should he examined periodically for acid leakage and

replaced as necessary. The battery should he

removed if the instrument is not used for an extended

period.

The transducer co-axial plug and socket

connections should be kept clean and protected

against sea water. The transducer cable should be

examined periodically for damage, particularly

where the cable emerges from the plastic transducer

stem.

The instrument should be carefully protected at all

times from salt water and the seals examined to

ensure that water is not allowed to penetrate the

nstrument.

Accessories and Spares

Additional or spare transducers as well as automatic

change-over, switches, repeat meters, mounting

brackets and visors are always readily available from

Yacht Chandlers, Dealers or Boatyards.

If you encounter a supply problem, please contact

Seafarer Navigation International Limited directly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

SEAFARER 5 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info