Bedienungsanleitung Seat Alhambra 2017 (Seite 289 von 320) (Englisch)

817366

289

Zoom out

Zoom in

Vorherige Seite

1/320

Nächste Seite

Wheels and tyres

Wheel bolts

Wheel bolts must be tightened to the correct

torque ››› page 84.

Beadlock wheel rims

Beadlock wheel rims have various compo-

nents. These are joined together by special

bolts using a special procedure. This ensures

good performance, a better seal, improved

safety and wheel run out. Therefore, worn

rims should always be replaced and must on-

ly be repaired in a specialised workshop.

SEAT recommends visiting a technical service

››› .

Wheel rims with bolted trims

Wheel rims may be fitted with interchangea-

ble trim parts which are attached to the rim

using self-locking bolts. Worn trims should

only be replaced at a specialised workshop.

SEAT recommends visiting a technical service

››› .

WARNING

The use of worn or damaged wheel rims could

make driving more dangerous and result in

serious accidents and damage.

●Only wheel rims which have been approved

for use with your vehicle should be used.

●Inspect wheel rims regularly for damage

and replace as required.

WARNING

If the bolted joints of wheel rims with bolted

ring trims are not correctly tightened or loos-

ened, this could result in serious accident.

●Never loosen the bolted joints of wheel

rims with bolted ring trims.

●Any work relating to wheel rims with bolted

rims should be carried out at specialised

workshop. SEAT recommends taking your car

in for technical service.

Note

A SEAT Service Centre should be consulted to

find out whether wheels or tyres of different

sizes to those originally fitted by SEAT can be

fitted, and to find out about the combinations

allowed between the front axle (axle 1) and

the rear axle (axle 2).

Replacement of wheel rims and new

tyres

New tyres

●When tyres are new, drive with extreme

caution for the first 500 km (310 miles), as

all tyres need to be run in. Tyres which have

not been run in do not have such good grip

or ››› braking capacity ››› .

●All four wheels must be fitted with radial

tyres of the same type, size (rolling circumfer-

ence) and the same tread pattern.

●The tread depth of new tyres may vary, ac-

cording to the type and make of tyre and the

tread pattern.

Replacing tyres

●Where possible, always replace both

wheels on an axle (both wheels on the front

axle or both wheels on the rear axle) ››› .

●Old tyres should only be replaced by SEAT

approved tyres for the vehicle in question,

and in accordance with the maximum permit-

ted size, diameter, load and speed capacity.

●If replacing tyres, make sure the new ones

have an emergency ride system (Conti-

Seal/Run flat). Otherwise, we recommend

carrying a tyre mobility system.

●Never use tyres which are larger than SEAT

approved tyres. If the tyres are too big, they

may knock or rub against the chassis or other

components, resulting in damage.

WARNING

New tyres do not give maximum grip and will

not have reached their maximum braking ca-

pacity to start with, and therefore need run-

ning in.

●To prevent accidents and major damage,

extreme caution should be taken for the first

500 km (310 miles). »

287

Technical dataAdviceOperationEmergenciesSafety

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Alhambra 2017 Seite 289

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Alhambra 2017

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info