Bedienungsanleitung Seat Alhambra 2019 (Seite 302 von 392) (Englisch)

817368

302

Zoom out

Zoom in

Vorherige Seite

1/392

Nächste Seite

Driving

●If the warning lamp  lights up, stop im-

mediately and check the tyres.

●If the tyres are inflated at different pres-

sures or if a tyre pressure is too low, this will

increase tyre wear, negatively affecting ve-

hicle stability and increasing braking dis-

tances.

●If tyres are inflated at different pressures

or a tyre pressure is too low, a tyre may be

damaged and burst resulting in a loss of

control of the vehicle.

●The driver is responsible for ensuring that

all of the vehicle tyres are correctly infla-

ted to the right pressure. The recommen-

ded tyre pressure is indicated on the label

››› Fig. 301.

●The tyre monitoring system can only op-

erate correctly if all of the tyres are infla-

ted to the correct pressure when cold.

●Driving with tyres at the wrong pressure

can damage them and result in an acci-

dent. Ensure that the tyre pressures of all

the tyres correspond to the vehicle load.

●Before starting a journey, always inflate

tyres to the correct pressure.

●If tyre pressure is too low then the tyre is

subject to greater forces and it may be

heated to such an extent that the tread can

rupture and the tyre will burst.

●With an overloaded vehicle at high

speed, the tyres can overheat and burst re-

sulting in a loss of vehicle control.

●Tyre pressures which are too high or too

low reduce the useful life of the tyre, affect-

ing vehicle performance.

●If a tyre has not been “punctured” and it

does not have to be changed immediately,

drive to the nearest specialised workshop

at a moderate speed and have the tyre

checked and inflated to the correct pres-

sure.

Tyre monitoring indicator

Fig. 279 Detail of the centre console: button

for the tyre pressure monitoring indicator

The tyre monitor indicator compares wheel

revolutions and, with this information, the

tread of each wheel using the ABS sensors. If

the tread of a wheel is changed, the tyre

monitoring indicator will indicate as such on

the instrument panel. The wheel tread

changes when:

●Tyre pressure is insufficient

●Tyre structure is damaged

●The vehicle is unbalanced because of a

load

●If the wheels on an axle are subject to a

heavier load (e.g. when towing a trailer).

●The vehicle is fitted with snow chains

●The wheel on one axle is changed

There may be a delay in the reaction of the

tyre monitoring indicator  or it may not indi-

cate anything under certain circumstances

(e.g. sports driving, snow-covered or unpaved

roads).

Adaptation of the tyre monitoring indica-

tor

On adjusting tyre pressure or changing one

or more wheels, the ››› Fig. 279 button on the

tyre monitoring indicator must be kept press-

ed down, with the ignition on, until an audible

warning is heard. Do the same, for example,

when the front and rear wheels are swapped

››› Fig. 300.

If the wheels are subjected to an excessive

load (towing a trailer, heavy load), the tyre

pressure must be increased to the maximum

recommended pressure ››› page 338. Press

the tyre monitoring indicator button to con-

firm the new pressure value.

300

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Alhambra 2019 Seite 302

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Alhambra 2019

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info