Bedienungsanleitung Seat Alhambra 2019 (Seite 346 von 392) (Englisch)

817368

346

Zoom out

Zoom in

Vorherige Seite

1/392

Nächste Seite

Practical tips

driving in winter, in cold temperatures and on

wet roads ››› .

The minimum tread depth required by law in

the majority of cases is 1.6 mm (1/16 of an

inch), measured in the tread grooves next to

the tread wear indicators. Observe legal re-

quirements in each country.

Winter tyres lose much of their performance

when their tread has worn to 4 mm

(5/32 inch).

The tread depth of new tyres may vary, ac-

cording to the type and make of tyre and the

tread pattern.

Wear indicators on the tyre

The original tyres on your vehicle have

1.6 mm (1/16 inch) high ››› Fig. 302 tread wear

indicators running across the tread. A number

of these indicators are equally spaced

around the tyre tread. Certain marks on the

tyre walls (e.g. the letters “TWI” or other sym-

bols) indicate the position of the wear indica-

tors.

Tread wear indicators indicate if a tyre is

worn. They must always be replaced before

the tyre tread has worn to the level of the in-

dicator.

WARNING

Driving with worn tyres is dangerous, and

may lead to loss of control of the vehicle

with serious consequences.

●Tyres must be replaced before the wear

indicators are at the same level as the

tread pattern.

●Worn tyres have significantly reduced

grip, especially on wet surfaces, increasing

the risk of “aquaplaning”.

●Worn tyres make control of the vehicle

more difficult in normal or difficult driving

conditions, increasing the braking distance

and the risk of skidding.

Tyre damage

Damage to wheels and tyres is often invisible

to the naked eye. If you notice unusual vibra-

tion or the car pulling to one side, this may

indicate that one of the tyres is damaged

››› .

●Slow down immediately if you think you

have a damaged wheel.

●Check the wheels and tyres for damage.

●If tyres are worn, stop driving and seek

qualified assistance.

●If there is no visible exterior damage, drive

slowly and carefully to the nearest special-

ised workshop and have the vehicle checked.

Foreign bodies in the tyre

●Do not remove foreign bodies if they have

penetrated through the tyre wall!

●If the vehicle comes with a tyre mobility

system, where necessary seal the damaged

tyre as shown in section ››› page 88. Use a

specialised workshop for repair or replace-

ment. SEAT recommends visiting a SEAT

dealership for this.

The sealant at the lower part of the tyre tread

wraps around the foreign body and provision-

ally seals the tyre.

Tyre wear

The wear of tyres depends on a number of

factors, for example:

●Driving style.

●Unbalanced wheels.

●Running gear settings.

Driving style: driving round bends quickly or

sudden acceleration or braking speed accel-

erates tyre wear. When the driving style is

normal, if the tyres wear too quickly, have the

running gear settings checked at a special-

ised workshop.

Eccentricity of the wheels: the wheels of a

new vehicle are balanced. However, certain

circumstances may lead to imbalance (run-

out), which is detected as vibrations in the

steering wheel. Run-out leads to wear of the

344

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Alhambra 2019 Seite 346

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Alhambra 2019

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info