Bedienungsanleitung Seat Ateca 2018 (Seite 313 von 348) (Englisch)

817355

313

Zoom out

Zoom in

Vorherige Seite

1/348

Nächste Seite

Wheels

●Avoid running the vehicle on tyres that are

more than 6 years old. If you have no alterna-

tive, you should drive slowly and with extra

care at all times.

●If wheel trims are fitted after the car is pur-

chased, ensure that there is an adequate flow

of air for cooling the brake system.

For the sake of the environment

Old tyres must be disposed of according to

the laws in the country concerned.

Note

●A SEAT Service Centre should be consulted

to find out whether wheels or tyres of differ-

ent sizes to those originally fitted by SEAT

can be fitted, and to find out about the com-

binations allowed between the front axle

(axle 1) and the rear axle (axle 2).

●Never mount used tyres if you are not sure

of their “previous history”.

●For technical reasons, it is not generally

possible to use the wheels from other vehi-

cles. In some cases, this may also be true for

the same model of wheel.

Wheel bolts

The wheel bolts are matched to the rims.

When installing different wheels (for instance

alloy wheels or wheels with winter tyres) it is

important to use the correct wheel bolts with

the right length and correctly shaped bolt

heads. This ensures that wheels are fitted se-

curely and that the brake system functions

correctly.

The wheel bolts must be clean and turn easi-

ly.

A special adapter is required to turn the anti-

theft wheel bolts* ››› page 65.

Tyre monitoring systems

Introduction

WARNING

Unsuitable handling of the wheels and tyres

may lead to sudden tyre pressure losses, to

tread separation or even to a blow-out.

●Check tyre pressures regularly and ensure

they are maintained at the pressures indica-

ted. Tyre pressure that is too low could cause

overheating, resulting in tread detachment or

even burst tyres.

●Tyre pressure should be that indicated on

the label when the tyres are cold at all times

››› page 319.

●Regularly check the cold inflation pressure

of the tyres. If necessary, change the tyre

pressure of the vehicle tyres while they are

cold.

●Regularly check your tyres for damage and

wear.

●Never exceed the maximum permitted

speed or loads specified for the type of tyre

fitted on your vehicle.

For the sake of the environment

Under-inflated tyres lead to increased fuel

consumption and tyre wear.

Note

●Driving for the first time with new tyres at a

high speed can cause them to slightly ex-

pand, which could then produce an air pres-

sure warning.

●Only replace used tyres with those author-

ised by SEAT for the corresponding type vehi-

cle.

●Do not only rely on the tyre monitoring sys-

tem. Regularly check your tyres to ensure

that the tyre pressure is correct and that the

tyres are not damaged due to puncture, cuts,

tears and impacts/dents. Remove objects

from the tyres only when they have not

pierced the tyres.

311

Technical dataAdviceOperationEmergenciesSafety

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Ateca 2018 Seite 313

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Ateca 2018

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info