Bedienungsanleitung Seat Exeo ST 2011 (Seite 70 von 319) (Englisch)

817458

Zoom out

Zoom in

Vorherige Seite

1/319

Nächste Seite

68 Cockpit

Electronic differential lock (EDL) fault

The EDL works in conjunction with the ABS. The ABS indicator lamp will light

up  to indicate an EDL fault. Please take the vehicle to a qualified work-

shop as soon as possible. For further information on the EDL, see

⇒ page 192.

WARNING

●Before opening the bonnet and checking the brake fluid level, ob-

serve the warning information in ⇒ page 226, Work in the engine com-

partment.

●If the brake warning lamp  should light up together with the ABS

warning lamp , stop the vehicle immediately and check the brake fluid

level in the reservoir. If the fluid level has dropped below the "MIN" mark

you must not drive on, as there is a risk of accident. Obtain technical as-

sistance.

●If the brake fluid level is correct, the fault in the brake system may

have been caused by a fault in the ABS control function. As a result, the

rear wheels can lock relatively easily when braking. Under certain cir-

cumstances, the rear of the vehicle could suddenly sway from side to

side, with the subsequent danger of skidding. Drive carefully to the near-

est specialised workshop and have the fault repaired. 

Seat belt warning lamp* 

The warning lamp acts as a reminder to the driver to fasten

the seat belt.

After switching on the ignition, the warning lamp  will remain lit until the

driver and front passenger (if applicable) have fastened their seat belts.

When the vehicle has reached a certain speed, you will also hear a warning

signal and the warning light will flash.

For further information on the seat belts, see ⇒ page 24. 

Turn signals and hazard warning lights  

Depending on which turn signal is operated, either the left  or right  turn

signal lamp flashes. Both turn signal lamps will flash when the hazard warn-

ing lights are switched on.

If a turn signal fails, the indicator lamp will start flashing twice as fast as

normal.

This does not apply when towing a trailer. Where a turn signal bulb does not

work, either on the trailer or on the towing vehicle, the turn signal bulb will

not flash. For further information on the turn signals, see ⇒ page 122. 

Electronic Stability Programme 

This warning lamp monitors the Electronic Stability Pro-

gramme (ESP).

The warning lamp  has the following functions:

●It will start flashing to indicate that ESP is counteracting an unstable

driving condition.

●It lights up when the ignition is switched on for approx. 2 seconds while

the function is checked.

●The warning lamp will light up if there is a malfunction in the ESP.

●It will light up after the battery has been disconnected.

●The warning lamp will light up if the ESP is switched off.

●It will also come on if a fault should occur in the ABS because the ESP

operates in conjunction with the ABS.

If the ESP warning lamp lights up and stays on after the engine is started,

this may mean that the control system has temporarily switched off the ESP.

In this case the ESP can be reactivated by switching the ignition off and 

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Exeo ST 2011 Seite 70

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Exeo ST 2011

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info