Bedienungsanleitung Seat Ibiza 2020 (Seite 317 von 360) (Englisch)

817317

317

Zoom out

Zoom in

Vorherige Seite

1/360

Nächste Seite

Wheels

Wheel tread change

The wheel diameter changes when:

●Tyre pressure is changed manually.

●Tyre pressure is insufficient.

●The tyre structure is damaged.

●The vehicle is unbalanced because of a

load.

●The wheels on an axle are subject to a

heavier load (e.g. with a heavy load).

●The vehicle is fitted with snow chains.

●The temporary spare wheel is fitted.

●The wheel on one axle is changed.

There may be a delay in the reaction of the

tyre  monitoring indicator or it may not indi-

cate anything under certain circumstances

(e.g. sporty driving, snow-covered or un-

paved roads, or when driving with snow

chains).

Calibrating the tyre monitoring indicator

After changing the tyre pressure or replacing

one or more wheels, the tyre monitoring indi-

cator must be recalibrated. Do the same, for

example, when the front and rear wheels are

swapped.

●Switch the ignition on.

●Store the new inflation pressure in the Easy

Connect system with the button    >

SETTINGS > Tyres ››› page 85 .

●Vehicles without the Easy Connect system:

press and hold button   ››› Fig. 279 until

a sound is heard.

When driving, the system self-calibrates the

tyre pressure provided by the driver and the

wheels fitted. After a long journey with varied

speeds the programmed values are collected

and monitored.

With the wheels under very heavy loads, the

tyre pressure must be increased to the total

recommended tyre pressure before calibra-

tion ››› Fig. 276.

If the tyre monitor system button is pressed

down, the new tyre pressures are confirmed.

WARNING

When the tyres are inflated at different

pressures or at a pressure that is too low

then a tyre may be damaged resulting in a

loss of control of the vehicle and a serious

or fatal accident.

●If the lamp  lights up, reduce speed im-

mediately and avoid any sudden turning or

braking manoeuvre. Stop when possible,

and check the tyre pressure and status.

●The tyre monitoring system can only op-

erate correctly if all of the tyres are infla-

ted to the correct pressure when cold.

●If a tyre has not been punctured and it

does not have to be changed immediately,

drive to the nearest specialised workshop

at a moderate speed and have the tyre

checked and inflated to the correct pres-

sure.

Note

●Driving for the first time with new tyres at

a high speed can cause them to slightly ex-

pand, which could then produce an air

pressure warning.

●Do not only rely on the tyre monitoring

system. Regularly check your tyres to en-

sure that the tyre pressure is correct and

that the tyres are not damaged due to

puncture, cuts, tears and impacts/dents.

Remove objects from the tyres only when

they have not pierced the tyres.

●The tyre monitoring indicator does not

function when there is a fault in the ESC or

ABS ››› page 262.

●If the battery is disconnected, the yellow

warning lamp  lights up after turning the

ignition on. This should turn off after a brief

journey.

315

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Ibiza 2020 Seite 317

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Ibiza 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info