Bedienungsanleitung Seat Leon 2020 (Seite 297 von 396) (Englisch)

817338

297

Zoom out

Zoom in

Vorherige Seite

1/396

Nächste Seite

Braking and parking

Automatically engaging and disengaging

the Auto Hold function

If the Auto Hold function was switched on with

the  button before disconnecting the igni-

tion, the function will remain on after the

ignition is re-connected.

If the Auto Hold function was not switched on,

it will automatically remain off next time the

ignition is engaged.

The Auto Hold function connects automat-

ically if the following conditions are met

(all points must be met at the same time

››› ):

The vehicle is kept stationary with the

brake pedal on a flat surface or on a

slope.

The engine rotates “correctly”.

The Auto Hold function is automatically

turned off if the following conditions are

met:

If any of the conditions mentioned on

››› page 294, Conditions for keeping

the vehicle stationary with the Au-

to Hold function are no longer met.

If the engine is running irregularly or an

anomaly is detected.

If the engine is turned off or stalls.

Manual gearbox: The clutch and the ac-

celerator are pressed at the same time.

Automatic gearbox: If the accelerator is

pressed

Automatic gearbox: If any of the tyres

has only minimal contact with the

ground, e.g. in the case of axle articula-

tion.

WARNING

The smart technology incorporated into

the Auto Hold function cannot defy the

laws of physics; it only works within the lim-

its of the system. The greater convenience

provided by the Auto Hold function should

never tempt you to take any risk that may

compromise safety.

●Never leave the vehicle running and with

the Auto Hold function switched on.

●The Auto Hold function cannot always

keep the vehicle stationary uphill or down-

hill or stop it sufficiently, for example, on

slippery or frozen surfaces.

Note

Before entering a car wash, always switch

off the Auto Hold function, because if the

electronic parking brake is automatically

connected, it may cause damage.

Hill driving assistant

3 Valid for vehicles without the Auto Hold func-

tion

The hill driving assistant helps the driver to

move off and upward on a hill, both forwards

and backwards, when the vehicle is station-

ary.

The system maintains brake pressure for ap-

proximately two seconds after the foot is tak-

en off the brake pedal, to prevent the vehicle

from moving when it is started. During these 2

seconds, the driver has enough time to re-

lease the clutch pedal and accelerate with-

out the vehicle moving and without having to

use the handbrake, making start-up easier,

more comfortable and safer.

These are the basic operation conditions:

●being on a ramp or hill/slope,

●driver door closed,

●vehicle completely stationary,

●engine running and foot on the brake,

●having a gear engaged or being in neutral

for a manual gearbox, or with the selector

lever at positions D/S or R for an automatic

gearbox.

WARNING

●If you do not start the vehicle immediate-

ly after taking your foot off the brake pedal,

the vehicle may roll back under certain »

295

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Leon 2020 Seite 297

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Leon 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info