Bedienungsanleitung Seat Leon 2024 (Seite 318 von 406) (Englisch)

817342

318

Zoom out

Zoom in

Vorherige Seite

1/406

Nächste Seite

316

Miscellaneous situations

10.

11.

Jump lead terminal connections

The jump leads should only be connected in

the order 1 > 2 > 3 > 4 ›››Fig.216.

Switch o the ignition of both vehicles

››› .

Connect one end of the red jump lead to

the positive + terminal of the vehicle with

the ﬂat battery A.

Connect the other end of the red jump lead

to the positive terminal + in the vehicle

providing assistance B.

Vehicles without a Start-Stop system:

connect one end of the black jump lead

to the negative terminal – of the vehicle

providing the current B ›››Fig.215.

Vehicles with a Start-stop system: connect

one end of the black jump lead X to a

suitable ground terminal, to a solid piece of

metal in the engine block, or to the engine

block itself ›››Fig.216.

Connect the other end of the black jump

lead X to a solid metal component bolted

to the engine block or to the engine block

itself of the vehicle with the ﬂat battery. Do

not connect it to a point near the battery A.

Position the leads in such a way that they

cannot come into contact with any rotating

part in the engine compartment.

Starting

Start the engine of the vehicle supplying

the current and leave it running at idle.

Start the engine of the vehicle with a dis-

charged battery and wait 2 to 3 minutes

until the engine runs.

Disconnecting the jump leads

Before disconnecting the jump leads,

switch o the dipped beam headlight if it

is on.

Turn on the heating fan and the vehicle's

heated rear window when the battery is

discharged to reduce the voltage peaks

that occur while disconnecting the battery.

While the engines are still running, discon-

nect the cables in the reverse order in

which they were connected.

If the engine does not start after 10 seconds,

wait for approximately 1 minute and then try

again.

WARNING

●Please note the safety warnings refer-

ring to working in the engine compartment

›››page325.

●The battery supplying the current must

have the same voltage (12V) as the ﬂat bat-

tery. Failure to comply could result in an ex-

plosion.

●Never use jump leads when one of the bat-

teries is frozen. Danger of explosion! Even

once thawed, electrolyte leaks can cause

burns. Replace the battery if it is frozen.

●Keep any sources of ignition (ﬂames, ciga-

rettes, etc.) far enough away from the batter-

ies. They may cause an explosion.

●Observe the usage instructions of the jump

lead manufacturer.

●On the other vehicle, do not connect the

negative cable directly to the negative ter-

minal of the discharged battery. Any sparks

could ignite the igniter gas coming out of the

battery and could cause an explosion.

●The negative wire must never be connec-

ted to fuel system components or brake lines

on the other vehicle.

●Do not touch uninsulated parts of the pole

clamps. The jump lead attached to the pos-

itive battery terminal must not touch metal

parts of the vehicle, this can cause a short

circuit.

●Jump leads must be placed in such a way

that they cannot be caught by rotating parts

in the engine compartment.

●Do not rest your body on the batteries, as

this could cause burns.

●Take into account the instruction manual of

the jump lead manufacturer and the instruc-

tion manual of the other vehicle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Leon 2024 Seite 318

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Leon 2024

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info