Bedienungsanleitung Seat Mii electric 2020 (Seite 184 von 232) (Englisch)

817313

184

Zoom out

Zoom in

Vorherige Seite

1/232

Nächste Seite

Practical tips

●Open the door and pull the lever that is un-

derneath the instrument panel ››› Fig. 159 1.

●Lift the bonnet slightly while pressing the

unlocking lever ››› Fig. 159 2 in the direction

of the arrow to fully open the bonnet.

●Remove the bonnet stay from its support in

the direction of the arrow ››› Fig. 160 3 and

place it in the opening provided for this pur-

pose 4 (arrow).

Closing the bonnet

●Slightly lift the bonnet.

●Release the bonnet stay and replace it in its

support.

●At a height of approximately 30 cm let it fall

so it locks.

If the bonnet does not close, do not press

downwards. Open it again and let it fall as

mentioned above.

WARNING

If the bonnet is not properly closed, it could

open unexpectedly while in motion and im-

pede forward visibility. This could cause

accidents and lead to serious injuries.

●After closing the bonnet, ensure that the

lock is duly engaged in the lock carrier. The

bonnet must be at the same level as the

adjacent parts of the bodywork.

●If while in motion you notice the bonnet is

not properly closed, stop the vehicle imme-

diately and close the bonnet.

●Open and close the bonnet only when

there is nobody in its path.

CAUTION

●To avoid damage to the bonnet and to the

wiper arms, open the bonnet only when the

wiper is disconnected and the wiper arms

are positioned on the windscreen.

●Before starting to move, always place the

wiper arms on the windscreen.

Cooling system

Control lamp

Flashes red

Excessive engine coolant temperature.

 Stop the vehicle! Stop the vehicle safely as soon

as possible. Disconnect the drive system and allow to

cool until the lamp switches off. If the lamp does not

switch off once the drive system has cooled down,

seek specialist assistance.

Insufficient engine coolant level.

 Stop the vehicle! Check the coolant level once

the drive system has cooled down and, if it is low, re-

fill with engine coolant ››› page 183.



Flashing red next to the dis-

play --.- on the instrument

panel.

Engine coolant system faulty.

 Stop the vehicle! Seek specialist assistance.

Several control and warning lamps light up

for a few seconds when the ignition is switch-

ed on while the function is verified. They will

switch off after a few seconds.

WARNING

Observe the safety warnings ››› in Con-

trol and warning lamps on page 70.

Coolant specifications

The engine cooling system is supplied from

the factory with a specially treated mixture of

water and at least 40 % of the additive

G12evo (TL-VW 774 J), purple. This mixture

gives the necessary frost protection down to

-25°C (-13°F) and protects the light alloy

parts of the engine cooling system against

corrosion. It also prevents scaling and con-

siderably raises the boiling point of the cool-

ant.

To protect the cooling system, the percent-

age of additive must always be at least 40 %,

even in warm climates where anti-freeze pro-

tection is not required.

182

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Mii electric 2020 Seite 184

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Mii electric 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info