Bedienungsanleitung Seat Tarraco 2019 (Seite 361 von 408) (Englisch)

817358

361

Zoom out

Zoom in

Vorherige Seite

1/408

Nächste Seite

Wheels

Do not forget the spare wheel when checking

the tyre pressures: Keep this spare wheel in-

flated to the highest pressure required for the

road wheels.

In the case of a minimised temporary spare

wheel (125/70 R18) inflate to a pressure of 4.2

bar as indicated on the tyre pressure label

››› Fig. 306.

Driving style

Fast cornering, heavy acceleration and hard

braking (squealing tyres) all increase tyre

wear.

Wheel balance

The wheels on new vehicles are balanced.

However, certain circumstances may lead to

imbalance (run-out), which is detected as vi-

brations in the steering wheel.

Unbalanced wheels should be rebalanced,

as they otherwise cause excessive wear on

steering, suspension and tyres. A wheel must

also be rebalanced when a new tyre is fitted

or if a tyre is repaired.

Incorrect wheel alignment

Incorrect running gear alignment causes ex-

cessive tyre wear, impairing the safety of the

vehicle. If you notice excessive tyre wear, you

should check wheel alignment at a SEAT Of-

ficial Service.

WARNING

●Always adapt the tyre pressure accord-

ingly when the vehicle load changes.

●A tyre with low air pressure has to flex a

lot more when the vehicle is heavily loaded

or at high speeds, therefore causing over-

heating to occur. Under these conditions,

the tyre bead may be released or the tyre

may burst. Risk of accident!

For the sake of the environment

Under-inflated tyres will increase fuel con-

sumption.

Wear indicators

Fig. 307 Tyre profile: tread wear indicators.

Tread wear indicators indicate if a tyre is

worn.

The original tyres on your vehicle have

1.6 mm high “tread wear indicators” running

across the tread. Depending on the manu-

facturer, there will be 6 to 8 of them spaced

at equal distances around the tyre. Markings

on the tyre sidewall (for instance the letters

“TWI” or a triangle) indicate the positions of

the tread wear indicators.

The minimum tread depth required by law is

1.6 mm (measured in the tread grooves next

to the tread wear indicators). (Different fig-

ures may apply in other countries.)

WARNING

The tyres must be replaced at the latest

when the tread is worn down to the tread

wear indicators. Failure to follow this in-

struction could result in an accident.

●Especially in difficult driving conditions

such as wet or icy roads. It is important that

the tyre tread be as deep as possible and

be approximately the same on the tyres of

both the front and the rear axles.

●The scant driving safety due to insuffi-

cient tread depth is particularly evident in

vehicle handling, when there is a risk of

“aquaplaning” in deep puddles of water

and when driving through corners, and

braking is also adversely affected.

●The speed has to be adapted according-

ly, otherwise there is a risk of losing control

over the vehicle.

359

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Tarraco 2019 Seite 361

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Tarraco 2019

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info