Bedienungsanleitung Seat Tarraco 2023 (Seite 83 von 408) (Englisch)

817362

Zoom out

Zoom in

Vorherige Seite

1/408

Nächste Seite

High-voltage battery

Charging cable

Fig.62 On the charging cable for power

sockets: Indicator lamps on the protection

device.

›››Fig.62:

Indicator lamp of the connector and the

power supply.

Control lamp of the protection device

Control lamp of the vehicle

Failure warning lamp

Charging cable information

Before using the charging cable, also follow the

instructions displayed on it and on the rear of

the protective device.

Protection device

The electronic protection device ›››Fig.62 en-

sures that the charging connector does not re-

ceive current until it is plugged in to the vehi-

cle's charging connector.

Self-check

When the charging cable is plugged into

the electrical socket, the protective device au-

tomatically performs a self-test. During this

check, all warning and indicator lamps turn on

brieﬂy and go out one after the other. Upon

completion, the operational status at that time

is displayed.

Operating displays

One or more control lamps ›››Fig.62 1 , 2 or

3 light up green.

Display ›››Fig.62 Meaning

1 ignition The charging cable is

plugged into the mains

1 , 2 on,

3 ﬂashes slowly

›››page81

The high-voltage battery

is charging.

1 2 and 3 on The charging process is

complete. The high-volt-

age battery has charged.

Set the charging current

The charging cable limits the charging current

according to the available power supply.

If the local mains supply does not allow charg-

ing at the maximum charging current, the

charging current can be reduced, depending

on the charging setting features in the infotain-

ment system ›››page78.

Temperature control

The charging cable temperature control

switches on when the charging cable over-

heats, such as when it has been stored in a lug-

gage compartment exposed to high tempera-

tures or strong sunlight.

Display ›››Fig.62 Meaning

1 , 4 ﬂashing The housing connector

has overheated.

2 , 4 ﬂashing The protection device has

overheated.

If the charging process continues with a lower

current, both the operating indicator and the

warning lamp ›››Fig.62 4 ﬂash red.

●Unplug the charging cable from the mains

and wait for it to cool down.

●If it disconnects again, or the charging cur-

rent reduces and the cause does not seem to

be exposure to an external heat source, make

sure that the green control lamp is ﬂashing

›››Fig.62. To check the charging cable, please

visit a SEAT dealer. Get an establishment that

specialises in electrical installations to check

the infrastructure connection.

Fault display

If the red warning light 4 ﬂashes or turns on

without one of the indicator lamps ›››Fig.62

1, 2 or 3 also turning on continuously on the

status indicator, there is a fault.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seat Tarraco 2023 Seite 83

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seat Tarraco 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info