Bedienungsanleitung Sencor SCE 3050SS (Seite 8 von 10) (Englisch)

688542

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

EN-8

Coffeemaker

SCE 3050SS / SCE 3051RD

Revision 05/2016

OPERATING THE COFFEEMAKER

1. Open the lid A1 and ﬁll the water tank A3 with the required amount of water. The water level

must at least cover the mark showing two water cups and must not go over the maximum mark

showing 10 water cups (i.e. 1.25 l).

Attention:

Only ﬁll the water tank with cold drinking water. Do not use hot water.

The water tank has a maximum capacity of 1.25 litres of water.

The amount of brewed coffee will always be less than the amount of water you poured into

the water tank A3. During the coffee brewing process, approximately 10 % of the water is

absorbed by the ground coffee.

2. Place the permanent ﬁlter A7 or a disposable paper ﬁlter size no. 4 into the ﬁlter holder A8.

3. Pour ground coffee into the ﬁlter. Recommended dosage: 7 g of ground coffee per cup. Set the hot

water arm A2 so that it points above the ﬁlter.

Note:

If you wish to brew tea, pour the required amount of tea into the ﬁlter.

4. Shut the lid A1 and make sure that it is properly closed.

5. Place the glass kettle with the lid Aqs on to the hotplate Aqd and start the coffeemaker by setting

switch Aqf to position I (On). The red indicator light will be lit.

6. Once the entire batch of coffee has ﬁnished brewing, wait approximately 1 minute for the drip

process to complete fully. Now the coffee can be served.

7. If you wish to serve the coffee later, leave the kettle Aqs on the hotplate Aqd. The hotplate Aqd will

keep the coffee at an optimal serving temperature. The coffeemaker will automatically turn itself

off after 40 minutes of operation.

8. Once you empty the kettle, return it back on to the hotplate Aqd and turn off the coffeemaker by

setting switch Aqf to position 0 (Off). The red indicator light will turn off.

9. Allow the coffeemaker to cool down for at least 10 minutes before using it again.

Warning:

If you do not allow the coffeemaker to cool down, the water could overheat and result in

subsequent scalding by the escaping steam.

10. Before using the coffeemaker again, remove the coffee grounds and wash the permanent ﬁlter

A7 or remove the paper ﬁlter together with the coffee grounds and dispose of it together with

normal household waste. Rinse the ﬁlter holder A8 and the kettle Aqs with clean water. Dry it and

put it back in its place.

11. When not using the coffeemaker, turn it off and disconnect it from the power socket.

DRIP-STOP FUNCTION

• The Drip-Stop function will allow you to serve coffee before the end of the drip process.

1. Once at least half the amount of coffee is brewed, you may remove the kettle Aqs from the

coffeemaker. The Drip-Stop shut-off valve will be activated and coffee will stop dripping.

2. Serve the required amount of coffee and place the kettle Aqs back on the hotplate Aqd within

approximately 1 minute of taking it off to avoid the ﬁlter from overﬁlling with hot water.

3. When the kettle Aqd is placed back under the brew chamber A9, the drip process will resume

automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sencor SCE 3050SS Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info