Bedienungsanleitung Sencor SCT 5051BMR (Seite 6 von 17) (Englisch)

757104

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

EN - 4

5. INSTALLATION/CONNECTION

Basic procedure:

1. Pull the key out of the ignition and then disconnect the  terminal on the car battery.

2. Correctly connect the input and output wires.

3. Install the device into the motor vehicle.

4. Reconnect the  terminal on the car battery.

5. Reset the device.

Warning:

• This device may only be installed in a motor vehicle with a 12 V DC power supply and

a grounded negative pole.

• If you connect the ignition wire (red) and the battery wire (yellow) to the vehicle's chassis

(grounding), you may cause a short circuit, which may subsequently cause a ﬁ re. Always

connect these wires to the power source via a fuse box.

• Prior to installing the device, disconnect the negative battery terminal and perform all

electrical connections.

• Insulate unconnected wires using vinyl tape or another similar material. To prevent

a short circuit, do not remove the covers on the ends of unconnected wires or terminals.

• After installation, do not forget to ground this device again to the vehicle's chassis.

• If the power supply is not turned on, the cause may be a short circuit of the speaker wire

or its contact with the chassis of the vehicle and the activation of the protective function.

Therefore, it is necessary to check the speaker wire.

Attention:

• If your vehicle's ignition does not have the ACC position, connect the ignition wire to the

power source that can be turned on and oﬀ using the ignition key. If you connect the

ignition wire to the power source with a constant voltage supply, e.g. battery wires, this

may discharge the battery.

• Install this device into the console of your vehicle. Make sure that the front panel does

not hit the lid of the console (if one exists) when opening and closing.

• After installing the device, check that your vehicle's brake lights, blinkers, wipers, etc.

are working correctly.

• Mount the device horizontally or at an incline of no more than 30°.

• In the event that the fuse melts, ﬁ rst make sure that the wires are not in contact and are

not causing a short circuit, and then replace the old fuse with a new one with the same

nominal values.

• Connect the speaker wires correctly to the respective terminals. If sharing  wires or if

you ground them to any metal part of the motor vehicle, the device may be damaged or

it may not function incorrectly.

• If you connect only two speakers to the system, connect them either only to the front

output or only to the rear output (do not combine the front and rear output).

• The installation and connection of this product required skill and experience. For reasons

of safety, have this work performed by professionals.

If you come across any problems during the installation, please contact a Sencor vendor.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sencor SCT 5051BMR Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info