Bedienungsanleitung Sencor SJE 1055 (Seite 7 von 10) (Englisch)

758814

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

Juicer

SJE 1055SS / SJE 1056RD / SJE 1057BK

EN-7

2016 02/2016

USING THE JUICER

1. Make sure that the juicer is correctly assembled and then connect it to the el. power socket. The juicer

is equipped with a safety mechanism that prevents it from being started unless it is correctly assembled.

2. Place the juice jug A0, a glass or another suitable container below the juice spout A7. Open the

juice spout A7 by tilting it downwards so that juice can ﬂow freely out of the juice collector during

juicing. Check that the pulp container A6 is installed in its place.

3. Prepare ingredients suitable for juicing (fruit and vegetables). Thoroughly wash them and cut them

up into pieces that will pass through the feed tube A2. Remove hard stones that are contained

in, for example, apricots, peaches, mangoes, etc. and inedible peels, e.g. from oranges, pineapples,

melons, mandarins, etc.

4. Prior to starting the juicer, make sure that the lid A3 is properly secured in the correct position.

Set the control dial Aqa to position I (low speed) or II (high speed) depending on the type of fruit

or vegetables that are being juiced. Use speed I for softer ingredients such as grapes, bilberries,

melons, raspberries, tomatoes, etc. Use speed II for harder ingredients such as bananas, celery,

carrots, beet, apples, etc. Take the pusher A1 out of the feed tube A2. Gradually add the prepared

ingredients into the feed tube A2 and push them down using the pusher. You will achieve optimal

results if you ﬁll the feed tube A2 gradually and push the ingredients down gently.

Attention:

Do not use ﬁngers or other utensils to push ingredients through the feed tube A2. Always use

the pusher A1 designed for this purpose.

The maximum time of non-stop operation of this appliance is 15 minutes. Then allow it to cool

down for 10 minutes.

When juicing larger batches of ingredients, do not run the appliance non-stop for longer than

10 seconds.

1. If the juice jug A5 or pulp container A6 ﬁll up during the juicing process, turn the juicer off by

turning the control dial Aqa to position 0 (off), empty out the respective container and then put it

back in its place. Then you can put the juicer back into operation and continue juicing.

2. To turn off the juicer, set the control dial Aqa to position 0 (off). Then disconnect the juicer from

the power socket. Prior to removing the juice jug A5, we recommended closing the spout A7 by

tilting it upwards so that juice does not drip out of it.

3. When you have ﬁnished using the juicer, disassemble it according to the instructions contained in

chapter Disassembling the juicer on pg. 8 and clean it out according to the instructions contained

in chapter Cleaning and maintenance on pg. 8. Before disassembling the juicer, make sure that the

juicer is turned off, disconnected from the power socket and that the rotating parts have stopped.

USEFUL ADVICE AND TIPS

• Before you start juicing, thoroughly wash all the ingredients and cut them up into smaller pieces

that will pass through the feed tube A2. Remove hard stones that are contained in, for example,

apricots, peaches, mangoes, etc. and inedible peels, e.g. from oranges, pineapples, melons,

mandarins, etc.

• To achieve optimal results, always process only fresh ripened fruits and vegetables. Overripe or

unripe fruits and vegetables will negatively affect the resulting taste of the juice.

• If you juice fruits and vegetables of varying consistency, we recommend that you start with the

softer fruits and vegetables, e.g. citruses, berries, etc. and then proceed on with harder fruits, e.g.

apples. Always select a speed appropriate for the type of ingredients that are being juiced.

• Do not use the juicer for processing frozen or excessively hard ingredients, e.g. sugar cane.

• Place the ingredients into the feed tube A2 gradually and push through gently with mild pressure.

Do not overﬁll the feed tube A2 and do not push the ingredients in too quickly and with excessive

pressure. The process of separating the juice from the pulp occurs gradually and will not be sped

up by pushing ingredients in quickly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sencor SJE 1055 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info