Bedienungsanleitung Sencor SSG 3501 (Seite 9 von 12) (Englisch)

758404

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Electric Slicer & Grater

SSG 3500WH / SSG 3501GR / SSG 3502BL / SSG 3503OR / SSG 3504RD

SSG 3505VT / SSG 3506YL / SSG 3507TQ / SSG 3508RS

EN-9

2015

01/2015

3. Before you start inserting food into the feed tube A2, press the switch A6 once or twice to ensure

that the attachment is properly seated on the shaft. Then hold down the switch A6 and start to

gradually insert food into the feed tube A2. Use the pusher A1 to push food through the feed

tube A2.

Attention:

Do not use your ﬁngers other items to push food in. Always use the pusher A1 designed for

this purpose.

The maximum continuous operating time is 2 minutes. Before turning it on again, allow the

appliance to cool down for at least 3 minutes.

4. To turn off the appliance, release the switch A6. When you have ﬁnished using it, disconnect the

appliance from the power socket and clean it out according to the instructions contained in the

'Cleaning and maintenance' chapter.

USEFUL TIPS

• Check the suitability of the individual attachments for speciﬁc food types in the 'Attachment type

selection' table.

• To achieve the best possible results, process fresh not overly ripened fruit. The same applies to

vegetables.

• You can place softer fruit such as strawberries into a freezer for a few minutes.

• Semi-hard cheese will be processed better if you place it in a refrigerator overnight or in a freezer

for 30 minutes.

• We do not recommend processing soft or already grated cheese as this could clog up the chamber A3.

• If you are using the ﬁne grater Aqs or the thin slicer attachment A9 then push the food through

the feed tube A2 gently. When using the coarse grater Aqa or the thick slicer A0, it is necessary

to push food through with greater force.

• This appliance is not designed for processing meat or types of food that are too hard to be cut with

a kitchen knife.

TROUBLESHOOTING

• This table shows situations that may arise when using the appliance. If the table does not help you

in resolving your problem, please contact an authorised service centre.

Problem Possible solution to the problem

When the switch A6 is pressed

and held down, the appliance

runs only intermittently or it

does not start up at all.

Turn off the appliance and disconnect it from the power socket and

wait for the rotating parts to come to a stop. Check that you have

assembled the appliance correctly according to the instructions in

the 'Assembling and disassembling the appliance' chapter.

The chamber A3 becomes

clogged during operation.

Pieces of food could have stuck to the attachment and clogged

the chamber A3. If this happens, turn off the appliance and

disconnect it from the power socket and wait for the rotating

parts to come to a stop. Remove the attachment and the chamber

A3. Then clean it out according to the instructions in the

'Cleaning and maintenance' chapter.

A greater force is needed to

push food through the feed

tube A2.

Harder types of food such as potatoes or hard cheese need to

be pushed through the feed tube A2 with greater force. This

is completely normal. Take a three minute break after every

2 minutes of operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sencor SSG 3501 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info