Bedienungsanleitung Sencor STM 6350 (Seite 3 von 10) (Englisch)

758533

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

05/2017

- 3 -

■ In the event that an item, such as aspoon, falls into the bowl during operation,

immediately set the speed control knob to the OFF position (stand-by mode), and

disconnect the power cord from the power socket. Wait until the rotating parts

come to astop and then remove the item.

■ If ingredients stick to the attachment or the sides of the bowl, turn the appliance

o, disconnect it from the power socket, and wait until the rotating parts come to

astop. Use asilicone spatula to clean the attachment and the inside of the bowl.

Then you can restart the appliance.

■ Make sure that no hair, clothing or other items enter the feed tube of meat grinder

while it is running. Do not put anything other than the ingredients that are to be

processed into the feed tube.

■ Never use your ngers or other items to push ingredients through the meat grinder

feed tube. For this purpose there is apusher included as an accessory.

Warning:

Incorrect use may lead to injuries.

■ To prevent injury caused by sharp edges, be especially careful when handling

the grinding blade of the meat grinder and the blade assembly of the blender.

Increased attention must also be paid when emptying out the blending jar, when

removing the blade assembly from the blending jar, when removing the grinding

blade from the chamber, and when cleaning the appliance.

■ Do not attempt to grind bones, nut shells or other hard ingredients.

■ Hot liquids up to atemperature of 80 °C may be processed in the blending

jar. Be especially careful when handling hot liquids. Hot steam or splashing hot

foods and liquids may cause scalding. Never start the blender without the lid

properly seated in position. When processing hot liquids, do not remove the inner

cap during operation. Do not touch the hot surface. Use the handle to carry the

blending jar when it is hot.

■ The maximum continuous operating time is 10 minutes. Do not exceed the

maximum operating time of 5 minutes when in the kneading mode and do not

exceed the maximum operating time of 2 minutes when using the blender. Before

starting it again, allow the appliance to cool down for 30 minutes.

■ Always turn o the appliance, disconnect it from the power socket when

not be using it, when leaving it without supervision, and before assembling,

disassembling, cleaning or moving it. Prior to disassembling the appliance and

replacing accessories or accessible parts that move during use, wait until all

moving parts come to astop.

■ Clean it according to the instructions in chapter Cleaning and maintenance.

■ Never wash the appliance under running water or submerge it in water or another

liquid.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sencor STM 6350 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sencor STM 6350

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info