Bedienungsanleitung Sencor STM 6377 (Seite 10 von 10) (Englisch)

758575

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

- 10 - 04/2021

Attention:

Under no circumstances should you attempt to process frozen food, nut

shells or hard stones that are found, for example, in mango or avocado.

2. Make sure that the food processor is correctly assembled and that the speed control knob

is set to the OFF position. Insert the power plug into an electrical power socket.

3. Place the the bowl A2 or another suitable container underneath the attachment. Use the

speed control knob to set the desired speed. We recommend to initially set the lowest

speed and then you may increase it as required.

4. Gradually add the ingredients into the feed tube B2 and push them through using the

pusher B1.

5. In the event that the attachment becomes blocked, turn off the food processor and

disconnect it from the power socket. Wait until rotating parts come to acomplete stop.

Remove the attachment and clean it out. Then assemble the attachment and reattach it

to the food processor. Connect the food processor to apower socket, turn it on and you

may continue working with it.

Attention:

When handling the grating cones B5–B9, be very careful not to injure

yourself on their sharp blades.

6. After you have finished using the appliance, set the speed control knob to the OFF position

and disconnect the power cord from the power socket.

7. Clean out the individual parts of the attachment after each use according to the instructions

in chapter Cleaning and maintenance.

CHOOSING THE RIGHT TYPE OF GRATING CONE

Food type Slicing cone

B8–B9

Coarse

grating

cone B7

Fine grating

cone B6

Very fine

grating

cone B5

Fruit

Apples • • •

Pears • • •

Vegetables

Red and white cabbage • • •

Carrot • • •

Zucchini • •

Cucumbers • •

Celery • • •

Onion • •

Potatoes • • •

Radish • • •

Sweet potatoes • • •

Other foods

Hard cheese

(e.g. Parmesan cheese) •••

Chocolate • • •

Hard baked goods

(for breadcrumbs) •

Nuts without shells •

Note:

The provided table only recommends the suitable type of grating cone for the

given type of food. If necessary, it is possible to use your preferred grating cone

for the given type of food.

The table includes the most common types of food that can be processed. However,

you can also use the grating and slicing cone for other types of food, for which it

generally applies that it can be normally cut using aknife.

CLEANING AND MAINTENANCE

■ Before cleaning the food processor, always switch it o by setting the speed control knob

A12 to the OFF position and disconnect it from the power socket.

■ Disassemble the food processor into its individual parts. Wait until moving parts come to

acomplete stop before disassembly.

■ Thoroughly wash the used removable parts after every use using warm water with aneutral

dishwashing detergent. Then rinse them under clean running water and wipe them dry with

ane wiping cloth or allow them to dry naturally. After washing and drying, we recommend

to coat the grinding blade B6 and the grinding plates B8, B9 andB10 with cooking oil.

■ If you whisked egg whites, rst rinse the bowl A10 and the beater A4 under cold water.

If you were to use hot water, the egg white remains would harden and their removal would

be more dicult.

■ Clean the mixing container C4 by lling it with 0.5 litre of clean water and afew drops of

kitchen detergent and then assemble the blender and run it for 10 to 15 seconds. Then turn

o the food processor, disconnect it from the power socket, and after the rotating parts have

come to astop, remove the blending jar assembly. Empty out the contents of the blending

jar C4 and then thoroughly rinse out the blending jar C4 with clean water and wipe dry.

■ If more thorough cleaning is required, the cu C5 with blade assembly C6 may be removed

using aspecial wrench that can be ordered free of charge at an authorised service centre.

After cleaning, it is necessary to install the cu C5 with blade assembly C6 back in its place

and to properly tighten it using the wrench.

Attention:

When cleaning, be very careful not to injure yourself on the sharp cutting

edge.

■ After every use, it is necessary to thoroughly clean any used attachments D6–D9 in

hot water and neutral kitchen detergent. Then rinse it under clean running water and

thoroughly wipe dry with ane wiping cloth.

■ The metal parts of the meat grinder, the blade assembly C6 and attachments A3–A5

are not intended for washing in adishwasher. Other removable parts may be washed in

adishwasher.

■ For cleaning the base unit A11 and the multi-function head A7, use acloth lightly dipped

in a weak detergent solution. Then wipe everything with a clean dampened cloth and

thoroughly wipe dry.

■ For cleaning, do not use solvents or cleaning agents with abrasive eects. Otherwise, the

surface of the appliance may be damaged.

■ Do not submerge the food processor or its power cord in water or any other liquids.

STORAGE

■ When not using the food processor, store it in a clean, dry place out of children’s reach.

Make sure that the multi-function head A7 is tilted down into the horizontal position.

TECHNICAL SPECIFICATIONS

Rated voltage range ............................................................................................................................... 220−240 V

Rated frequency...........................................................................................................................................50/60 Hz

Rated power input ........................................................................................................................................1 000 W

Noise level .......................................................................................................................................................85 dB(A)

The declared noise emission level of the appliance is 85 dB(A), which represents alevel Aof

acoustic power with respect to areference acoustic power of 1 pW.

INSTRUCTIONS AND INFORMATION REGARDING THE

DISPOSAL OF USED PACKAGING MATERIALS

Dispose of used packaging material at asite designated for waste in your municipality.

DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT

This symbol on products or original documents means that used electric or

electronic products must not be added to ordinary municipal waste. For

proper disposal, renewal and recycling hand over these appliances to

determined collection points. Alternatively, in some European Union states or

other European countries you may return your appliances to the local retailer

when buying an equivalent new appliance.

Correct disposal of this product helps save valuable natural resources and

prevents potential negative eects on the environment and human health,

which could result from improper waste disposal. Ask your local authorities or

collection facility for more details.

In accordance with national regulations penalties may be imposed for the incorrect disposal

of this type of waste.

For business entities in European Union states

If you want to dispose of electric or electronic appliances, ask your retailer or supplier for the

necessary information.

Disposal in other countries outside the European Union

This symbol is valid in the European Union. If you wish to dispose of this product, request the

necessary information about the correct disposal method from the local council or from your

retailer.

This product meets all the basic requirements of EU directives related to it.

Sencor STM 6377 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info