Bedienungsanleitung Sencor SWK 1785 (Seite 7 von 8) (Englisch)

759068

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Electric Kettle

SWK 1785BK

EN-7

2016

08/2016

USING THE KETTLE

1. Set the desired length of the power cord. Push the power cord into the groove in the base. Place

the base on a stable, even and clean surface.

2. Fill the kettle with the required amount of water. The water level must reach at least the minimum

mark (0.5 l) and must not exceed the maximum mark (1.7 l). You may ﬁll the kettle through the

spout or through the opening after lifting the lid. The lid can only be opened once the lid lock,

located in the middle of the lid, is released. After ﬁlling the kettle with water, close the lid and push

it down so that it is secured in the closed position.

Warning!

Never ﬁll the kettle when it is located on the base.

If the electric kettle is overﬁlled, then boiling water could splash out.

3. Place the kettle on the base. Insert the power plug into an electrical power socket. Check that the

lid of the kettle is closed.

4. Start the kettle by setting the switch to position I (On). The inside of the kettle will be illuminated.

Attention:

Do not turn on the kettle when it is empty. The incorrect use of the kettle may negatively affect

its lifetime. If you accidentally turn on the electric kettle without water, the thermostat will,

after reaching a certain temperature, interrupt the electric circuit and the kettle light inside will

turn off. The kettle can be used again after several minutes, as soon as its stainless steel bottom

has cooled down.

5. When the water starts to boil, the kettle will turn off automatically and the kettle light inside will

turn off. Before taking the kettle off the base, check that it has turned itself off automatically. If it

has not automatically turned itself off, turn off the kettle manually by setting the switch to position

0 (Off).

Note:

The operation of the kettle can be interrupted at any time by setting the switch to position 0

(Off).

6. Pour the boiled water into a prepared container, cup or mug. Make sure that it remains in a vertical

position when it is carried, particularly if it is ﬁlled all the way up to the maximum mark.

If you wish to open the lid to reﬁll the kettle, ﬁrst empty all the contents of the kettle so that you

are not scalded by the escaping steam.

7. After you ﬁnish using the kettle, disconnect the power cord from the el. power socket. Empty the

kettle and allow it to cool down.

CLEANING AND MAINTENANCE

• Regularly remove water scale deposits from inside the kettle based on how frequently the kettle

is used. During standard use of the kettle (3 to 5 times per day), we recommend to remove water

scale deposits:

– once per month in areas with hard and very hard water;

– once every two to three months in areas with soft and medium hard water.

• To remove water scale deposits it is possible to use:

– 8% white vinegar, generally available in stores. Put ½ l of vinegar into the kettle and allow it

to settle for 2 hours without boiling. Then empty the kettle and before further use, boil clean

water in it four to ﬁve times.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sencor SWK 1785 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info