471985
18
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
Using the transmitter
16
Activating/deactivating the RF signal
To deactivate the RF signal:
To activate the RF signal:
Monitoring the audio signal via headphones
You can monitor the audio signal via the headphone output.
̈ Set the headphone volume control · to the minimum position.
̈ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ³.
̈ Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
Synchronizing transmitters and receivers via the infra-red
interface
Easy Setup Sync function (EK 300 IEM G3 -> SR 300 IEM G3)
Once you have performed a frequency preset scan with your EK 300 IEM G3 receiver (see the
instruction manual of the receiver), you can use the Easy Setup Sync function to transfer
unused frequency presets from the receiver to several transmitters via the infra-red
interface. The receiver transfers the first unused channel from the current frequency bank to
the first transmitter and the next unused channel to the second transmitter and so on.
̈ When the standard display is shown on the display panel, briefly press the
STANDBY button.
RF Mute On?” appears on the display panel.
̈ Press the jog dial.
The RF signal is deactivated. The transmission icon
is not displayed.
In
addition, the display backlighting changes from orange to red and “RF Mute
flashes in alternation with the standard display.
̈ Press the STANDBY button.
RF Mute Off?” appears on the display panel.
̈ Press the jog dial.
The RF signal is activated and the transmission icon
is displayed.
The display
backlighting changes from red to orange.
You can also deactivate the RF signal on switch-on. For more information, refer to
the chapter “Switching the transmitter on/off” on page 14.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
̈ Set the headphone volume control · to the minimum position before putting the
headphones on.
̈ Do not continuously expose yourself to high volumes.
³ ·
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sennheiser SR 300 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info