Bedienungsanleitung Sephra CF34R2 (Seite 13 von 20) (Englisch)

603250

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

7) Re-Assembling & Refilling the Chocolate Fountain

a) To re-assemble, place the removable bowl back on the fountain, then attach the cylinder

to the bowl. Place the black stabilizer on the auger (See Photo 5.8) and slide the auger

into the cylinder. Slide the tiers on starting with the widest and ending with the narrowest,

followed by the crown.

b) Add sufficient chocolate callets (chips) to the bowl to bring the level of chocolate up to the

minimum or desired amount required for the following day’s activities. See section 3(a)

for minimum & maximum chocolate fountain chocolate levels. By placing the chocolate

callets in the bowl the night before you ensure that the callets will be melted and at the

optimal temperature to run through the fountain following day. See Section 3(d) for

overnight temperatures.

When leaving the chocolate to melt overnight set the temperature dial to 5 or 140º.

c) To ensure the chocolate remains clean and free of dust or any other objects that may

come in contact with we recommend using a Sanitary Wind Guard. (See Photo 5.11 on

page 9.) If you opt to cover the bowl and cylinder by an alternative means, do not cover

the ventilation holes found on the top section of the basin just beneath the Bowl. This

may cause the fountain to overheat and shut down.

(Estimated time 10 minutes)

8) Daily Set Up Procedure

a) Carefully remove the Sanitary Wind Guard from around the fountain. Rotate the auger by

hand to ensure that it will turn freely and is not bound in the cylinder by hardened

chocolate. If the tiers and crown need to be placed onto the Cylinder, do so now.

b) When the chocolate is melted and at its optimal level click the rocker switch in the back of

the fountain to the “Start” or “On” setting and adjust the temperature to dial number 7 or

160°F for Sephra’s dark or milk Chocolate. Refer to Section 3(c) for chocolate operating

temperatures.

c) The chocolate level in the bowl will drop as the chocolate is pulled up the cylinder. An

even flow of chocolate should cascade over each of the tiers using any of the Sephra

brands of chocolate.

i) Assuming the chocolate fountain is level7, if the chocolate that is cascading over each

tier is not creating a full curtain it may be necessary to turn the rocker switch on the

chocolate fountain from “Start” to “Off” for no more than 30 seconds. This will enable

any bubbles in the cylinder to clear. After no more than 30 seconds, click the rocker

switch back to “Start” or “On”

d) Ensure that the optimal amount of Sephra chocolate is in the bowl.

(Estimated time 15 minutes)

7 Level the chocolate fountain by adjusting the three adjustable feet found at the bottom of the base. A level

may be necessary. Once the fountain is level the chocolate should create a full curtain when falling over

each tier.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sephra CF34R2 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sephra CF34R2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info