Bedienungsanleitung Severin BK-7300 (Seite 9 von 30) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

712438

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Dear Customer,

Before using the appliance please read the

following instructions carefully.

Connection to the mains supply

The baby bottle sterilizer should only be

connected to an earthed socket installed in

accordance with the regulations. Make sure

that the supply voltage corresponds with the

voltagemarked on therating label.

This product complies with EEC Directives

89/336/EEC and 73/23/EEC.

Familiarisation

1. Rating label

2. Base unit

3. Power cord

4. Main switch

5. Indicator lamp

6. Heatingelement

7. Bottle holder

8. Adaptorring

9. Holder insert

10. Lid

11. Steam outlet

Important safety instructions

● The surface of the housing as well as the

insertsheat up during operation.

● Beware of hot steam escaping from the

unit. Do not open the lid while the unit is

switched on.

● Do not allow the appliance to operate

withoutsupervision.

● Do not allow the power cord to come

into contact with any hot parts of the

appliance and do not coil the power cord

around the unit.

● Always remove the plug from the wall

socket

- after use,andalso

- in case of any malfunction

- beforecleaning the appliance.

● Do not operate the sterilizer if the

appliance or the power cord show any

signs ofdamage.

● No responsibility is accepted if damage

results from improper use, or if these

instructions are not compliedwith.

● This appliance is intended for domestic

use only and not for commercial

applications.

● In order to comply with safety

regulations and to avoid hazards, repairs

of electrical appliances must be carried

out by qualified personnel, including the

replacement of the power cord. If repairs

are needed, please send the appliance to

one of our customer service departments.

The address can be found in the

appendix to this manual.

Before using for the first time

Before the appliance is used for the first

time, all parts must be thoroughly cleaned as

described in the section General Care and

Cleaning.

Main switch

The baby bottle sterilizer is activated by the

main switch. The unit switches off

automatically and cannot be switched off

manually. Before inserting the plug into a

suitable wall socket, ensure that the unit is

filled and ready for operation, since it may

alreadybe switchedon.

Operation

Place the unit on a level and waterproof

surface.

Round the heating area, there is a deep

recess in the base unit. This recess must

be filled with approx. 100 ml cold fresh

water without any additional agents or

additives.

Place the bottle holder inside the unit.

The bottles are placed (without their

tops) onto the bottle holder with the

openings facing downwards.

● Before sterilizing can take place, the

bottlesmust be thoroughly cleaned.

When sterilizing longer bottles, the

Baby bottle sterilizer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin BK-7300 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info