Bedienungsanleitung Severin ES 3571 (Seite 13 von 80) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

668412

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

5. Place the worm drive with the opening facing down into

the worm-drive housing, turning it lightly left and right

until it is seated ﬁ rmly on the rubber seal.

6. Fit the lid with the feeder tube onto the worm-drive

housing, so that the markings and face

each other.

7. Lock the lid by turning clockwise, until the two triangular

markings face each other.

8. Lift up the locking latch on the rear of the drive unit.

9. Place the pulp container under the pulp outlet and the

juice container under the juice outlet.

10. Insert the plug into a mains socket. The appliance is

now ready for use.

Extracting juice from fruit and vegetables

1. Prepare the appliance as described in the section

Assembling the appliance (sieve insert I or II).

2. Set the switch to the I position and lift up the ﬂ ap on the

juice outlet.

3. The appliance starts operating.

4. Feed the clean, pre-cut fruit or vegetable pieces

down the feeder tube while the unit is running, using

the pestle to push the pieces lightly down. Caution:

Excessive pressure may result in damage to motor or

ﬁ lter.

5. If unsuitable or excessive ingredients are loaded into

the appliance, it may jam. Should this occur, press the

button for reverse operation to remove the blockage.

You may also have to press the reset button ﬁ rst (see

Thermal safety cut-out).

6. During operation, ensure that juice does not

accumulate in the worm-drive. If it does, switch the

appliance off, disconnect it from the mains and, if

necessary, remove any blockage in the pulp or juice

outlet.

7. When processing large quantities of fruit or vegetables,

the pulp and juice containers must be emptied from

time to time, as necessary.

8. When the juice stops coming out, switch the appliance

off and remove the plug from the wall socket.

9. Clean the appliance immediately after use.

Hint: The juice should be consumed right away, or stored

in a suitable container and kept in a refrigerator (but only

for a short time). In this way, vitamins and nutrients are

preserved.

Making jam

1. Prepare the appliance as described in the section

Assembling the appliance (sieve insert II).

2. Extract the juice - see Extracting juice from fruit and

vegetables.

3. Without delay, put the juice, together with the pulp,

into a saucepan and prepare the jam according to the

recipe.

Some sample recipes can be found towards the end of this

manual, or at www.severin.de/service/recipes

Making sorbets

Hint: Sorbets are easily made from frozen fruit or

vegetables. Simply freeze the food items overnight, and

let them brieﬂ y thaw before processing.

1. Prepare the appliance as described in the section

Assembling the appliance (sorbet insert).

2. Set the switch to the I position.

3. The appliance starts operating. With the motor running,

put the frozen fruits or vegetables into the feeder

tube and push down with the pestle. Caution: Avoid

excessive pressure to prevent damage to the motor

and ﬁ lter.

4. If unsuitable or excessive ingredients have been loaded

into the appliance, it may jam. Should this occur,

press the button for reverse operation to remove the

blockage.

5. When processing large quantities of sorbet, the juice

container must be emptied from time to time, as

necessary.

6. When the sorbet stops coming out, switch the

appliance off and remove the plug from the wall socket.

7. Clean the appliance immediately after use.

Tip: The sorbet should be consumed right away, or

stored in a suitable container, and kept (for a short time

only) in a refrigerator. Vitamins and nutrients will then be

preserved.

After use

∙ The appliance should be thoroughly cleaned immediately

after each use. For details, please refer to the section

Cleaning and care.

∙ Remove the juice and pulp containers.

∙ Take off the pestle.

∙ Release the locking latch. Turn the lid with its feeder tube

anti-clockwise and take it off.

∙ Take off the worm-drive housing. Remove the worm drive

and take out the sieve inserts.

∙ Clean all components - see Cleaning and care.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin ES 3571 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info