Bedienungsanleitung Severin GS 8858 (Seite 22 von 52) (Deutsch, Englisch, Holländisch, Französisch)

761641

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

- 22 -

Making ice cubes

A special ice-cube tray is provided for making

ice cubes. Fill the tray up to ¾ with drinking

water and place it in the freezer compartment

for a few hours. The ice cubes are easier to

remove from the tray if the tray is left stand-

ing at room temperature for 5 minutes.

Cleaning and Defrosting (Maintenance)

Cleaning

• Always pull the mains plug before cleaning.

• Do not pour water into the appliance.

• Tepid water with a bit of washing-up liquid

is suitable for the regular maintenance.

• Clean the equipment separately with rins-

ing water, not in the dishwasher.

• Do not use aggressive, abrasive or alcoholic

detergents.

• After cleaning it with clear water, wipe the

surface and carefully dry it off. Subsequent-

ly, plug the mains plug with dry hands.

• In order to save energy and maintain the

efciency, you should clean the condenser

(on the backside) and the compressor at

least twice a year with a broom or vacuum

cleaner.

• The rating label in the interior of the appli-

ance cannot be damaged or even removed

while cleaning.

Defrosting

If the ice layer in the interior is 2-4 mm thick,

the appliance must be defrosted. Clean it at

least twice a year.

• Disconnect the mains plug from the socket.

• Remove food from the appliance and store

it as cool as possible, e.g., together with

ice packs and covered in a plastic recipi-

ent. Please remember that the lifetime of

the goods is shortened by the temperature

increase and that they should be consumed

as quickly as possible.

• Leave the door open. To speed up defrost-

ing, place one or more pots with hot but

not boiling water in the freezer.

• Warning! Do not use other mechanical

devices or any other means, e.g., heating

appliances, to speed up defrosting.

• Dry the appliance thoroughly after cleaning.

• Plug in the mains plug. Wait approx. 5

minutes and set the temperature controller

to the desired position.

Tips for Energy Saving

• For the installation of the appliance, choose

a cool, dry and well-aired room.

• Protect the appliance from direct insolation.

It should not be installed near heat sources

(stove, heater etc.). If this cannot be avoid-

ed, some sort of isolation between heat

source and appliance has to be used.

• Don’t cover the ventilation openings and

grid. Provide enough circulation of air on

the backside of the appliance.

• Let warm food cool down before you store

it in the fridge.

• Do not leave the door open too long when

withdrawing or putting food inside. Other-

wise, the formation of ice in the interior will

be accelerated.

• Do not set the temperature lower than

necessary. More details on temperature

settings can be taken from the chapter

‘Operating elements’.

Operation Noises

There might be some typical operation noises

when the appliance is turned on. These are:

• Noise of the electric

motor is arising from

the working compressor.

When the compressor

starts to operate, then

the noises get slightly

louder for a short time.

• Noises in the tubes of the circulation of the

refrigerant.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin GS 8858 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info