Bedienungsanleitung Severin HS 0701 (Seite 10 von 50) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

712545

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

battery must be fully charged, which will take

about one hour. However, the appliance can

remain on charge for a longer period without

damage or danger.

If you experience a considerable decrease in

trimming performance, or if the indicator light

shows red, switch off the appliance and

recharge the battery.

Insert the connecting plug of the adapter

into the corresponding jack on the charging

base.

Ensure that the trimmer is switched off and

place it in the charging base.

Insert the adapter into a suitable wall

socket. The charging process begins

automatically and is shown by the rapid-

flashing red indicator light on the charging

base.

When the battery is fully charged, the

indicator light shows a slow-flashing green

light.

Once the charging process is complete,

always remove the adapter from the wall

socket first before disconnecting the jack

from the charging base.

While charging, the transformer within the

adapter will become warm. This is perfectly

normal and safe and does not indicate a

malfunction of any kind.

If the appliance has not been used for a

long period, the capacity of the battery may

decrease by a certain amount. However,

full capacity will be restored after several

charge/discharge cycles.

Use

Cutting length fine adjustment

The cutting length is adjustable, from 1 to 3

mm, in five steps by turning the cutting length

control back or forth, as required. With the

control turned back all the way (the flat section

is visible), the cutting length is 1mm. With it

turned forward all the way, the cutting length is

3mm.

Trimming head

When fitting a trimming head, ensure that it is

safely locked by the locking buttons on either

side. To remove a trimming head, push it away

to one side.

3/6 mm and 9/12 mm trimming heads

The trimming heads provide cutting lengths of

3, 6, 9 and 12 mm.

Set the control in such a way that the markings

on the adjustment wheel are properly aligned

with the corresponding dots on the housing.

Tapered trimming head

The tapered trimming head is designed for

cutting the hair while avoding a 'stepped'

effect.

In this way, the hair above the ears is cut

shorter, while remaining longer towards the top

of the head. For the right side of the head, the

attachment marked 'Right Taper' should be

used; for the opposite side use the one

marked 'Left Taper'. Start trimming from the

back of the head and cut the hair against its

natural direction of growth towards the

temples, before changing the attachment to

trim the opposite side.

Operation

■ Before each use, always put a few drops of

acid-free oil between the trimming comb

and the trimming blade.

Always start with the highest setting of the

push-on comb.

The hair should first be combed, and then

generally cut against its natural direction.

For longer hair-cuts use the push-on comb

or a normal comb.

Cut from bottom to top with the trimming

comb lying against the head; lead the

appliance upwards through the hair, moving

it gradually away from the head at the same

time.

For a shaped cut, reverse the appliance

and shorten the hair from top to bottom

without using the push-on comb.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin HS 0701 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info